Operating centrifugal pumps under two-phase flow conditions presents challenges such as phase separation, cavitation, and flow instabilities, compromising reliability and performance. A specialized design is crucial to mitigate these issues. This study utilized computational fluid dynamics (CFDs) to understand two-phase flow behavior and assess the impact of different blade geometries on pump performance under such conditions. For this purpose, the inhomogeneous multiphase model was employed, wherein the momentum and continuity flow equations were individually solved for each phase across three different impellers with varying blade angle distributions. The computational results indicated higher gas concentrations on the pressure side of the blade, with gas pocket size correlating with flow rate and inlet gas concentration. The blade angle distribution’s effect was more pronounced with increased gas concentrations, while a tendency of gas bubbles to coalesce towards the impeller shroud was also observed. The presence of gas promoted flow recirculation and separation, substantially reducing impeller performance. Blade angle distribution critically influenced the flow field, affecting flow separation, stability, efficiency, and overall performance, highlighting the importance of optimized blade design for enhanced centrifugal pump performance in liquid–gas two-phase flow conditions.
In the present case study, a moisture diffusion model is developed to simulate the drying kinetics of Lavandula x allardii leaves for non-stationary convective drying regimes. Increasing temperature profiles are applied over the drying duration and the influence of temperature advancing rates on the moisture removal and the drying rate is investigated. The model assumes a one-dimensional moisture transfer under transient conditions, which occurs from the leaf center to the surface by liquid diffusion due to the concentration gradient developed by the surface water evaporation caused by the difference of water vapor partial pressure between the drying medium and the leaf surface. A numerical solution of Fick’s 2nd law is obtained by an in-house code using the finite volume method, including shrinkage and a variable temperature-dependent effective moisture diffusion coefficient. The numerical results have been validated against experimental data for selected cases using statistical indices and the predicted dehydration curves presented a good agreement for the higher temperature advancing rates. The examined modeling approach was found stable and can output, in a computationally efficient way, the temporal changes of moisture and drying rate. Thus, the present model could be used for engineering applications involving the design, optimization and development of drying equipment and drying schedules for the examined type of non-stationary drying patterns.