In this work, amorphous hydrogen-free silicon nitride (a-SiN_x) and amorphous hydrogenated silicon nitride (a-SiN_x:H) films were deposited by radio frequency (RF) sputtering applying various amounts of hydrogen gas. Structural and optical properties were investigated as a function of hydrogen concentration. The refractive index of 1.96 was characteristic for hydrogen-free SiN_x thin film and with increasing H₂ flow it decreased to 1.89. The hydrogenation during the sputtering process affected the porosity of the thin film compared with hydrogen-free SiN_x. A higher porosity is consistent with a lower refractive index. Fourier-transform infrared spectroscopy (FTIR) confirmed the presence of 4 at.% of bounded hydrogen, while elastic recoil detection analysis (ERDA) confirmed that 6 at.% hydrogen was incorporated during the growing mechanism. The molecular form of hydrogen was released at a temperature of ~65 °C from the film after annealing, while the blisters with 100 nm diameter were created on the thin film surface. The low activation energy deduced from the Arrhenius method indicated the diffusion of hydrogen molecules.

Ga₂O₃ is a promising material in the optoelectronics and semiconductor industry. In this work, gallium oxide thin films were deposited via radio frequency (RF) sputtering, using a liquid Ga target. The reactive sputtering was carried out using different oxygen flow rates and DC target potentials induced via the RF power. The thickness of the samples varied between 160 nm and 460 nm, depending on the preparation conditions. The composition and the refractive index of the layers were investigated via energy-dispersive spectroscopy, X-ray photoelectron spectroscopy, and spectroscopic ellipsometry, respectively. It was found that, through the use of a lower DC target potential, a better film quality and higher oxygen content can be achieved. The reactive sputtering was modeled based on the Berg model, with the aim of determining the sputtering yields and the sticking coefficient. It was shown that an increase in DC target potential leads to the preferential sputtering of gallium.

Multilayers of hydrogenated ultrathin (3 nm) amorphous a-Si and a-Ge layers prepared by sputtering have been studied by atomic force microscopy (AFM) and transmission electron microscopy (TEM) to check the influence of annealing on their structural stability. The annealed multilayers exhibit surface and bulk degradation with formation of bumps and craters whose density and size increase with increasing hydrogen content and/or annealing temperature and time. Bumps are due to the formation of H₂ bubbles in the multilayer. The craters are bumps blown up very likely because of too high a gas pressure inside. The release of H from its bonds to Si and Ge occurs within cavities very likely present in the samples. The necessary energy is supplied by the heat treatment and by the recombination of thermally generated carriers. Results by energy filtered TEM on the interdiffusion of Si and Ge upon annealing are also presented.

In a single process run, an amorphous silicon oxynitride layer was grown, which includes the entire transition from oxide to nitride. The variation of the optical properties and the thickness of the layer was characterized by Spectroscopic Ellipsometry (SE) measurements, while the elemental composition was investigated by Energy Dispersive Spectroscopy (EDS). It was revealed that the refractive index of the layer at 632.8 nm is tunable in the 1.48–1.89 range by varying the oxygen partial pressure in the chamber. From the data of the composition of the layer, the typical physical parameters of the process were determined by applying the Berg model valid for reactive sputtering. In our modelling, a new approach was introduced, where the metallic Si target sputtered with a uniform nitrogen and variable oxygen gas flow was considered as an oxygen gas-sputtered SiN target. The layer growth method used in the present work and the revealed correlations between sputtering parameters, layer composition and refractive index, enable both the achievement of the desired optical properties of silicon oxynitride layers and the production of thin films with gradient refractive index for technology applications.

Gradient a-Si_1−xGe_x layers have been deposited by ”one-sample concept” combinatorial direct current (DC) magnetron sputtering onto one-inch-long Si slabs. Characterizations by electron microscopy, ion beam analysis and ellipsometry show that the layers are amorphous with a uniform thickness, small roughness and compositions from $x=0$ to $x=1$ changing linearly with the lateral position. By focused-beam mapping ellipsometry, we show that the optical constants also vary linearly with the lateral position, implying that the optical constants are linear functions of the composition. Both the refractive index and the extinction coefficient can be varied in a broad range for a large spectral region. The precise control and the knowledge of layer properties as a function of composition is of primary importance in many applications from solar cells to sensors.