To produce ultra low-sulfur gasoline and meet the new regulations, the improvement of the HDS reaction by the removal of inhibitors, like nitrogen-containing compounds (N-compounds) commonly found in middle distillates used for diesel feed, could be worth considering. Liquid–liquid extraction using 1-butyl-3-methyl-imidazolium chloride (BMIm+Cl−) was found to be a very promising approach for the removal of neutral N-compounds with high selectivity towards sulfur. BMIm+Cl− was first evaluated using synthetic solution with dibenzothiophene and carbazole as model compounds, and a high selectivity for N-compounds was found. In order to explain the observed selectivity, the extraction of heterocyclic aromatic compounds from a hydrocarbon mixture by BMIm+Cl− was studied as the function of the toluene/n-dodecane ratio. The extraction of sulfur-containing compounds and basic N-compounds decreased when the mass fraction of toluene increased, whereas the extraction of proton donor N-compounds was found to be almost independent of the mass fraction of toluene. We thus assumed that the selective extraction of indole and carbazole by BMIm+Cl− could be explained both by electron pair acceptor properties of the imidazolium ring and by the binding of the hydrogen-donor group with chloride anion of the RTIL. BMIm+Cl− was then evaluated using straight-run diesel feed, containing 13400 ppm S and 105 ppm N. An extraction of up to 50% of the N-compounds was obtained in one step, whereas the sulfur concentration reduction was only 5%. The selectivity of the extraction process towards heterocyclic aromatic compounds and polyaromatic compounds using BMIm+Cl− was further emphasized by two-dimensional GC-MS analysis of the extracted compounds.
Aryl ethers have been prepared from cyclohexanone derivatives and various alcohols in the presence of a catalytic amount of palladium on charcoal. The formation of an enol ether followed by an aerobic or non-aerobic dehydrogenation reaction, seem to be the key steps of this transformation. In addition, this new method was also adapted for the synthesis of arylamines.
A direct synthesis of paracetamol (acetaminophen) from hydroquinone has been developed using ammonium acetate as an amidating agent. The reaction proceeds in acetic acid at elevated temperatures without any metallic catalyst. Under these conditions, paracetamol was obtained with high yield and selectivity (>95%). The reaction has also been carried out on the multi-gram scale (44 g of hydroquinone) and a potential process has been proposed based on the recycling of the solvent and by-products. This amidation protocol has also been extended to other phenol derivatives.
17 September 2010 in Journal of Chemical & Engineering Data