This paper presents the process of developing a new procedure for estimating the buckling capacity of spherical shells. This procedure is based entirely on the assumptions included in the standard mentioned, EN-1993-1-6 and also becomes a complement of EDR5th by unifying provisions included in them. This procedure is characterized by clarity and its algorithm is characterized by a low degree of complexity. While developing the procedure, no attempt was made to change the main postulates accompanying the dimensions of the spherical shells. The result is a simple engineering approach to the difficult problem of determining the buckling capacity of a spherical shell. In spite of the simple calculation algorithm for estimating the buckling capacity of spherical shells, the results obtained reflect extremely accurately the behavior of real spherical shells, regardless of their geometry and the material used to manufacture them.

Steel, spherical shells subjected to an external pressure are exposed to the loss of stability and such a phenomenon determines the global resistance of such shells. Unavoidable, geometric imperfections present is this class of shells affect significantly global resistance of shells. The imperfection form corresponding to the first and second buckling modes, analysed in previous works of authors, do not cover all possible and observed in reality imperfection modes. The specification and comparison of other imperfections encountered in practice will allow to identify the most adverse ones. Additionally to the imperfection forms also their amplitudes were analysed. Consequently the ranges in which considered imperfection form is in fact the most adverse were determined. On the basis of this knowledge, the designer can choose the most adverse imperfection mode for given quality fabrication class of the shell.

Existing provisions leading to the assessment of the buckling resistance of pressurised spherical shells were published in the European Design Recommendations (EDR) [1]. This book comprises rules which refer to the stability of steel shells of different shapes. In the first step of the general procedure they require calculation of two reference quantities: the elastic critical buckling reference p_Rcr and the plastic reference resistance p_Rpl. These quantities should be determined in the linear buckling analysis (LBA) and in the materially nonlinear analysis (MNA) respectively. Only in the case of spherical shells the existing procedure has exceptional character. It is based on the geometrically nonlinear analysis (GNA) and on the geometrically and materially nonlinear analysis (GMNA), respectively. From this reason, in this particular case there was a need to change the existing approach. The new procedure was presented in the work of Błażejewski & Marcinowski in 2016 (comp. [2]). All steps of the procedure leading to the assessment of buckling resistance of pressurized steel, spherical shells were presented in this work. The elaborated procedure is consistent with provisions of Eurocode EN1993-1-6 (comp. [3]) and with recommendations inserted in Europeans Design Recommendations [1]. The proposed capacity curves were compared with existing proposal published in [1] for three different fabrication quality classes predicted in [3]. In this work also comparisons of author’s proposals with experimental results obtained by other authors were presented.