Biomaterials used for the manufacture of biomedical devices must have suitable surface properties avoiding bacterial colonization and/or proliferation. Most biomaterial-related infections start during the surgery. Bacteria can begin colonization of the surface of a device right after implantation or in the next few hours. This time may also be sufficient to begin the deterioration of a biodegradable implant. This work explores the surface changes that hydrophobic films of poly(lactic) acid reinforced with Mg particles, prepared by solving-casting, undergone after in vitro degradation at different times. Hydrophobicity, surface tension, zeta potential, topography, and elemental composition were obtained from new and aged films. The initial degradation for 4 h was combined with unspecific bacterial adhesion and viability tests to check if degraded films are more or less susceptible to be contaminated. The degradation of the films decreases their hydrophobicity and causes the appearance of a biocompatible layer, composed mainly of magnesium phosphate. The release of Mg²⁺ is very acute at the beginning of the degradation process, and such positive charges may favor the electrostatic approach and attachment of Staphylococci. However, all bacteria attached on the films containing Mg particles appeared damaged, ensuring the bacteriostatic effect of these films, even after the first hours of their degradation.

The study of the surface properties of materials is key in determining whether the material will be suitable for medical purposes. One of these properties is hydrophobicity, which is important when assessing its behavior against bacterial adhesion. In this work, we have studied the influence of the solvent (chloroform, acetone, and tetrahydrofuran) and the substrate (glass, PTFE, silicone, and Ti6Al4V) on which polylactic acid is deposited in solution to manufacture films by solvent-casting. Thus, it has been found that there are no significant differences in hydrophobicity and surface tension among the solvents evaluated, but there are significant differences with respect to the substrates: PLA films casted on silicone are hydrophobic, while those casted on the rest of the substrates are hydrophilic. This is related to the fact that the silicone interacts with the polymer modifying its spatial arrangement, exposing its methyl groups towards the interface with the air. In this way, it has been shown that, when manufacturing PLA films, it is important to choose the right surface on which to deposit them, depending on their desired function.

Cycloaddition reactions between N-alkyl and N-aryl-substituted maleimides and furan derivatives have been carried out using the ‘on-water’ methodology. Transformations are faster and products can easily be isolated by simple workup protocols, often in quantitative yields.

Eco-friendly “on water” reactions of carbohydrate-derived nitroalkenes with furan, 2-methylfuran and furfural N,N-dimethylhydrazone have been investigated under different mixing methods, such as a magnetic stirrer and a wrist-action shaker. Cyclic and acyclic furyl derivatives from carbohydrates were obtained with high diastereoselectivity.