Graphite nanoplatelets (GNPs) are bidimensional carbon nanostructures consisting of stacks of graphene sheets, having thickness in the range from one up to a few tens of nanometers, and lateral linear dimension in the micrometer range. These nanostructures represent a good candidate to replace carbon nanotubes in composites for electromagnetic applications. This paper proposes a new model based on the Maxwell-Garnett approach to compute the effective complex permittivity of GNP-filled nanocomposites. The effect of the dimensional probabilistic distribution of the nanofiller is investigated. To this purpose, an extensive experimental characterization of the morphological and physical properties of the GNPs after synthesis is performed. The proposed model is validated by comparison with the measured effective permittivity of GNP-composites with different concentrations, and it is used for the design of radar-absorbing materials in the frequency range 1-18 GHz.

An innovative broadband adaptive absorber, providing a reflection coefhcient lower than -10 dB in the frequency range from 7 to 22 GHz, is proposed. The new absorber is a two-period dielectric Salisbury, in which the outer lossy sheet is made of a graphene monolayer, and the inner one consists of a tunable graphene/dielectric laminate (GL). The two dielectric spacers are made of a commercial low-loss polymer. The total thickness is ~ 6 mm. The adaptive broadband response of the absorber is achieved tuning the effective sheet resistance of the GL through an applied electrostatic held bias. The sensitivity analysis of the reflection coefhcient of the absorber illuminated by a plane wave with normal incidence is carried out with respect to the spacer thickness and the graphene carrier charge mobility. By applying a dc-voltage source always below 15 V, the minimum reflection coefhcient of the adaptive absorber is centered around 14 GHz, and it is characterized by a bandwidth at -10 dB of ~15 GHz.

The strain-dependent electrical resistance of polyvinyl ester-based composites filled with different weight fractions of graphene nanoplatelets (GNPs) has been experimentally investigated. The GNP synthesis and nanocomposite fabrication process have been optimized in order to obtain highly homogeneous filler dispersion and outstanding electrical properties. The produced nanocomposites showed a low percolation threshold of 0.226 wt% and electrical conductivity of nearly 10 S m−1 at only 4 wt% of GNPs. The piezoresistive response of thin nanocomposite laminae has been assessed by measuring the variation of the electrical resistance as a function of the flexural strain in three-point bending tests under both quasi-static monotonic and dynamic cyclic loading conditions. The obtained results showed higher strain sensitivity than traditional metal foil strain gauges or recently investigated carbon-based nanocomposite films.

Development of epoxy or epoxy-based vinyl ester composites with improved mechanical and electromagnetic properties, filled with carbon-based nanomaterials, is of crucial interest for use in aerospace applications as radar absorbing materials at radio frequency. Numerous studies have highlighted the fact that the effective functional properties of this class of polymer composites are strongly dependent on the production process, which affects the dispersion of the nanofiller in the polymer matrix and the formation of micro-sized aggregations, degrading the final properties of the composite. The assessment of the presence of nanofiller aggregation in a composite through microscopy investigations is quite inefficient in the case of large scale applications, and in general provides local information about the aggregation state of the nanofiller rather than an effective representation of the degradation of the functional properties of the composite due to the presence of the aggregates. In this paper, we investigate the mechanical, electrical, and electromagnetic properties of thermosetting polymer composites filled with graphene nanoplatelets (GNPs). Moreover, we propose a novel approach based on measurements of the dielectric permittivity of the composite in the 8–12 GHz range in order to assess the presence of nanofiller aggregates and to estimate their average size and dimensions.