Large quantities of soil excavated from civil engineering projects are found to contain leachable contaminants, including metallic oxyanions like molybdate. This study presents a novel treatment approach by identifying a mixture of magnesium oxide (MgO) and hydraulic binders for the stabilization and solidification (S/S) of molybdenum-contaminated limestone tunnel sludge. XRD analysis and geochemical modeling revealed the presence of brucite in all samples, suggesting that the immobilization mechanism was likely molybdate sorption onto brucite. The addition of cement enhanced the geotechnical properties and improved sulfate retention through the formation of ettringite. Considering efficiency and a low CO2 footprint, the S/S formulation consisting of 1 wt% MgO and 3 wt% limestone calcined clay cement (LC3) was selected for this study. Environmental assessments were conducted using leaching test standards, including US EPA 1313 to assess pH sensitivity, US EPA 1311 (TCLP) and EN 12457-2 to evaluate the effects of curing time, at intervals from 6 hours to 90 days. Results showed that molybdenum release remained below 0.05 mg/L (the European inert waste threshold) after just 24 hours of curing, with further improvements over time under alkaline conditions. However, the treatment was ineffective at neutral or acidic pH due to brucite dissolution. The S/S of molybdenum-contaminated sludge using MgO and LC3 proved highly efficient for Mo immobilization and is suitable for industrial applications.
The use of carbon nanofibers (CNFs) in cement systems has received significant interest over the last decade due to their nanoscale reinforcing potential. However, despite many reports on the formation of localized CNF clusters, their effect on the cement paste micromechanical properties and relation to the mechanical response at the macroscopic scale are still not fully understood. In this study, grid nanoindentation coupled with scanning electron microscopy and energy dispersive spectroscopy was used to determine the local elastic indentation modulus and hardness of a portland cement paste containing 0.2% CNFs with sub-micro and microscale CNF clusters. The presence of low stiffness and porous assemblage of phases (modulus of 15–25 GPa) was identified in the cement paste with CNFs and was attributed primarily to the interfacial zone surrounding the CNF clusters. The CNFs favored the formation of higher modulus C–S–H phases (>30 GPa) in the bulk paste at the expense of the lower stiffness C–S–H. Nanoindentation results combined with a microscale–macroscale upscaling homogenization method further revealed an elastic modulus of the CNF clusters in the range from 18 to 21 GPa, indicating that the CNF clusters acted as compliant inclusions relative to the cement paste.
1 February 2009 in Journal of Environmental Management