Fei Xi

Prof. Dr. Fei Xi

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 May 2023 in Polymer Composites
Verified
Journal Article
Closed access
FXFei Xi
Fei Xi
LZLonglong Zhao
Longlong Zhao
Yang WeiYang Wei
Yang Wei
Jiyang YiJiyang Yi
Jiyang Yi
KZKang Zhao
Kang Zhao
1



17 September 2022 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
LZLonglong Zhao
Longlong Zhao
FXFei Xi
Fei Xi
QWQinglong Wang
Qinglong Wang
Yang WeiYang Wei
Yang Wei
Five specimens were cut from an aluminum alloy thin-walled hollow column to complete a tensile test, and the strength of the aluminum alloy was measured to be 200.18 MPa. The Ramberg–Osgood model was compared with the stress-strain relationship of the test results, and the fitting regression coefficient was more than 0.99. Four groups of axial compression trials of aluminum alloy thin-walled hollow columns with different heights were accomplished, and the test phenomena and data were concurrently observed and recorded. The results show that the axial compressive bearing capacity of aluminum alloy thin-walled hollow columns does not change with the change in column height, the mean value is 73.72 kN, and the corresponding covariance is only 2.14%. Local buckling failures appeared in all of these columns, and the failure locations were distributed at each height of the test pieces. The stiffness of the column decreased with the increase in height and width ratio, and the varying trend between them obeys exponential distribution. The displacement that corresponds to the ultimate load increased with the increase in the height-width ratio, and the increasing trend follows a linear relationship with the change in column height.

9 March 2026 in SSRN Electronic Journal
Verified
Preprint
Open access
FXFei Xi
Fei Xi
LZLonglong Zhao
Longlong Zhao
JYJun Yang
Jun Yang
RORongxian Ou
Rongxian Ou
Wood–plastic composite (WPC) is widely employed for nonstructural components in buildings because of its environmentally friendly characteristics. However, its inherent mechanical deficiencies, such as high temperature sensitivity, significant creep, and susceptibility to brittle failure, limit its use for structural components. To improve the structural properties of WPC, basalt fiber-reinforced polymer (BFRP) was chosen in this study to externally confine and strengthen WPC hollow columns, with a focus on investigating the influence of the number of BFRP layers (zero, one, two, and three layers) on the axial compressive properties of columns. Through the use of systematic axial compression tests, the failure mechanism, load–displacement response, load–strain relationship, ultimate bearing capacity, and ductility of the specimens were analyzed in detail. The test results revealed that BFRP confinement significantly increased the load-bearing capacity and ductility of the specimens. Compared with those of unreinforced specimens, the ultimate load and ductility factor of specimens reinforced with three BFRP layers increased by 74.19% and up to 127.96%, respectively. On the basis of the test data, prediction models for the ultimate stress, ultimate strain, and full stress–strain curve (based on the Hognestad model) of BFRP-reinforced WPC hollow columns were established. The calculation results of the established models showed good agreement with the test results. This study provides an experimental basis and theoretical support for the application of WPC in load-bearing structural components.