Oxide metallurgy technology can improve the microstructure of a coarse-grained heat-affected zone (CGHAZ) but introduces extra inclusions. Local corrosion behavior of the CGHAZ of a Zr–Ti–Al–RE deoxidized steel was investigated in this work using theoretical calculations and experimental verification. The modified inclusions have a (Zr–Mg–Al–Ca–RE)Ox core claded by a CaS and TiN shell. CaS dissolves first, followed by the oxide core, leaving TiN parts. This confirms that the addition of rare earth can reduce lattice distortion and prevent a galvanic couple between the inclusions and the matrix, while the chemical dissolution of CaS causes localized acidification, resulting in the pitting corrosion initiation.
20 August 2018 in Journal of Materials Engineering and Performance
A modelling effort was made to try to predict the life of downhole tubes or casings, synthetically considering the effect of service influencing factors on corrosion rate. Based on the discussed corrosion mechanism and corrosion processes of downhole tubes, a mathematic model was established. For downhole tubes, the influencing factors are environmental parameters and stress, which vary with service duration. Stress and the environmental parameters including water content, partial pressure of H2S and CO2, pH value, total pressure and temperature, were considered to be time-dependent. Based on the model, life-span of an L80 downhole tube in oilfield Halfaya, an oilfield in Iraq, was predicted. The results show that life-span of the L80 downhole tube in Halfaya is 247 months (approximately 20 years) under initial stress of 0.1 yield strength and 641 months (approximately 53 years) under no initial stress, which indicates that an initial stress of 0.1 yield strength will reduce the life-span by more than half.
Body-centered cubic (BCC) metals, extensively utilized in low-alloy high-strength steels and heat-resistant alloys, exhibit a pronounced ductile-brittle transition (DBT) at cryogenic temperatures, marked by a well-defined yet narrow DBT temperature (DBTT) window. Unlike face-centered cubic (FCC) and hexagonal close-packed (HCP) metals, BCC metals’ DBT is governed by the temperature-dependent mobility of screw dislocation. Below DBTT, suppressed thermal activation reduces screw dislocations mobility relative to edge dislocations, thereby inducing inefficient dislocation sources. Further, screw dislocations slide by forming kink pairs in advance, which is a low-energy way relative to climbing over in whole. Substitutional solute (e.g., Re, Pt in W/Mo/Cr alloys) promote double-kink nucleation by lowering the Peierls potential and valley. On the macro scale, it induces a phenomenon behaving as a reduction of yield stress at cryogenic temperatures, called "dilute solution softening". This contrasts with conventional solid-solution strengthening and exists in dilute-solution BCC alloys (alloy content < 1 at. %). However, studies remain confined to superficial phenomena and theoretical calculations, lacking the direct evidence of solute-screw dislocation interactions. While extensively explored in refractory metals and alloys, the effect is rarely studied in BCC iron or low-alloy steels. It would be a potential strategy to exploit this effect to reduce the DBTT of low-alloy steels. Meanwhile, this effect also provides a cost-effective and resource-saving way for developing low-temperature resistant steels compared to conventional Ni-series steels and medium/high-manganese steels.
5 February 2026 in Journal of Materials Research and Technology