Adi Setiawan

Dr. Adi Setiawan

orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2015 in Catalysis Today
Verified
Journal Article
Closed access
ASAdi Setiawan
Adi Setiawan
EKEric M. Kennedy
Eric M. Kennedy
Bogdan DlugogorskiBogdan Dlugogorski
Bogdan Dlugogorski
AAAdesoji A. Adesina
Adesoji A. Adesina
MSMichael Stockenhuber
Michael Stockenhuber

3 March 2014 in Catalysis Science & Technology
Verified
Journal Article
Closed access
PDF file
ASAdi Setiawan
Adi Setiawan
JFJarrod Friggieri
Jarrod Friggieri
EKEric M. Kennedy
Eric M. Kennedy
Bogdan DlugogorskiBogdan Dlugogorski
Bogdan Dlugogorski
MSMichael Stockenhuber
Michael Stockenhuber
In this paper, we report new insights into the deactivation phenomenon of palladium based catalysts for catalytic combustion of ventilation air methane (VAM). It was found that the primary factor responsible for low temperature catalyst deactivation is the water vapour present in the feed stream. The influence of water vapour on VAM was examined by comparing the properties of fresh catalysts with catalysts following over 1000 h reaction time-on-stream. The techniques applied to characterize the catalysts included TPD, XRD, N2-isotherm adsorption, H2-chemisorption and XPS analyses. Alternating between dry and water vapour-saturated VAM feed disclosed ca. 50% reversible drop in activity. XPS analysis suggests an absence of a palladium hydroxide phase during the initial 2 h on stream, although prolonged exposure to the reactant leads to the formation of palladium hydroxide, which appears to match the progressive deactivation of the Pd/Al2O3 catalyst. Introduction of VAM dust (a mixture of fine coal, CaCO3 and aluminosilicate particles) causes a variation in catalytic activity originating from coal-dust ignition and the effect of chloride on the surface of the catalyst. In the presence of these inhibiting agents, an average methane conversion of higher than 75% over 1100 h was achieved at reaction temperatures below 600 °C.

5 March 2014 in Energy Technology
Verified
Journal Article
Closed access
PDF file
ASAdi Setiawan
Adi Setiawan
EKEric M. Kennedy
Eric M. Kennedy
Bogdan DlugogorskiBogdan Dlugogorski
Bogdan Dlugogorski
AAAdesoji A. Adesina
Adesoji A. Adesina
OTOlga Tkachenko
Olga Tkachenko
MSMichael Stockenhuber
Michael Stockenhuber

1 November 2019 in IOP Conference Series: Earth and Environmental Science
Verified
Conference Paper
Open access
PDF file
ASAdi Setiawan
Adi Setiawan
FHF Hayat
F Hayat
FAFaisal
Faisal
TNTaufiq Bin Nur
Taufiq Bin Nur
Increasing number of coffee-by-products highlights its potential as source of renewable energy. The use of coffee pulp as a raw material for bio-briquettes is considered as an effective way to minimize their wastage as landfill. This study aims to examine the combustion characteristics of bio-briquettes produced from Gayo Arabica coffee-pulp which was carbonized through a slow pyrolysis process and densified at a pressure of 150 kg/cm2. Prior to densification process, the raw material was sun-dried, pyrolyzed, ground and sieved to mesh 20. A mixture was then made by adding starch binder at 20, 30 and 40 wt.% followed by molding and drying processes. Characterization of the briquette employs a number of techniques including DSC, bomb calorimeter and proximate analyses as well as combustion test. The results show that the amount of starch-binder significantly affects the rate of combustion and the flame duration. However, no significant change is found in term of calorific value, moisture and ash content.

1 August 2022 in Journal of Ecological Engineering
Verified
Journal Article
Open access
PDF file
ASAdi Setiawan
Adi Setiawan
MZMuhammad Zakarya
Muhammad Zakarya
AAAlchalil Alchalil
Alchalil Alchalil
TNTaufiq Bin Nur
Taufiq Bin Nur
Coffee pulp and husk are the primary residues of the coffee agro-industry. Disposing of them into the land can bring a serious problem on the environment. Strategies are needed to convert it into more valuable products as well as reduce the risk of environmental damage. This paper reports...

28 May 2015 in Catalysis Science & Technology
Verified
Journal Article
Closed access
PDF file
ASAdi Setiawan
Adi Setiawan
JFJarrod Friggieri
Jarrod Friggieri
GBGlenn Bryant
Glenn Bryant
EKEric M. Kennedy
Eric M. Kennedy
Bogdan DlugogorskiBogdan Dlugogorski
Bogdan Dlugogorski
MSMichael Stockenhuber
Michael Stockenhuber
In this report, the characteristics of Pd/Al 2 O 3 catalyst after long-term stability tests in catalytic combustion of simulated ventilation air methane gas were investigated with the objective of understanding catalyst deactivation phenomena.