In a wide-angle synthetic aperture radar (SAR), as the isotropic scattering assumption becomes invalid, scattering characteristics of targets tend to be aspect-dependent. In this paper, based on the high center frequency characteristic of Video SAR (ViSAR), a ViSAR aspect-dependent scattering imaging algorithm (VADSIA) is proposed, which includes two main procedures of persistent polar format algorithm (PPFA) and generalized likelihood ratio test (GLRT). Through PPFA, sequential ViSAR sub-aperture images (sub-images) can be formed to the same orientation with the same image resolution efficiently, providing the advantage of easy extraction and display of the aspect-dependent scattering characteristic. Different from conventional algorithms that require 2-D aspect-dependent interpolation procedures, PPFA utilizes a uniform lookup table scheme and a 2-D Chirp-Z transform (2D-CZT) to realize persistent sub-aperture imaging. As PPFA includes only 2-D fast Fourier transforms and multiplications, it is suitable for parallel implementation to realize real-time imaging. Besides, with the persistent imaging ability of PPFA, an efficient approximate GLRT process can be applied on the formed sub-images directly, which can preserve both the aspect-dependent scattering characteristics and the azimuth resolution of targets at the same time. Combining PPFA with GLRT, VADSIA is an effective and efficient way for the aspect-dependent imaging. The ground-based experimental results validate the effectiveness of the proposed algorithm.
28 December 2018 in IEEE Geoscience and Remote Sensing Letters
Video synthetic aperture radar (ViSAR) is a novel imaging model to persistently surveil the region of interest by a series of consecutive images in real time. The formation time of one frame image, which can influence the image latency, is one of the key factors to realize ViSAR system. In general, the polar format algorithm (PFA) is preferred for ViSAR imaging. However, the 2-D resampling in the PFA has a large computation burden and is complex to realize in the real-time processing system. It has become the main obstacle to reduce image latency. Therefore, we derive four judgment criteria in this letter. According to these criteria, we propose the improved method of the PFA. Based on this method, the modified PFA can reduce the image formation time while guaranteeing the image quality. Simulation results are presented to validate the effectiveness of the improved method proposed in this letter.
27 September 2018 in IEEE Transactions on Terahertz Science and Technology
Video synthetic aperture radar (ViSAR) is a novel imaging mode where the radar system forms a sequence of SAR images while the radar platform is flying. To achieve a high frame rate, ViSAR system typically operates in the terahertz (THz) band. In this paper, the unified coordinate system algorithm (UCSA) improving on the polar format algorithm (PFA) is proposed for THz ViSAR images formation, which is based on the more accurate wavenumber domain signal model derived by second-order Taylor expansion. Considering the small synthetic angle feature of THz ViSAR, the UCSA divides two-dimensional (2-D) resampling into range and azimuth resampling using the chirp z-transform (CZT) to reduce the processing complexity in ViSAR imaging. Through the analysis in this paper, it can be known that THz PFA images are free from the quadratic phase errors (QPE). However, the PFA images are oriented to different directions and exist image distortion caused by linear phase errors (LPE). Through an image resampling, the UCSA corrects the LPE and rotates the images to the unified coordinate system simultaneously. The effectiveness of UCSA is validated by a ground-based experiment performed by a 0.3 THz radar system.
Video synthetic aperture radar (ViSAR) can produce sequential images at a high frame rate, which provides a persistent surveillance over a region of interest. However, due to position changes of different apertures, most of existing imaging algorithms fail since the orientation and resolution of each frame image will change accordingly. In this article, based on the high centre frequency characteristic of ViSAR, an interpolation‐free algorithm for persistent multi‐frame imaging is proposed. The proposed algorithm can be implemented by only two‐dimensional fast Fourier transforms without any image post‐processing, thus both the efficiency and quality of imaging are obtained at the same time. Simulation and real data results have verified the effectiveness of the proposed algorithm.
Unmanned aerial vehicle borne frequency modulated continuous wave synthetic aperture radars are attracting more and more attention due to their low cost and flexible operation capacity, including the ability to capture images at different elevation angles for precise target identification. However, small unmanned aerial vehicles suffer from large trajectory deviation and severe range-azimuth coupling due to their simple navigational control and susceptibility to air turbulence. In this paper, we utilize the squint minimization technique to reduce this coupling while simultaneously eliminating intra-pulse motion-induced effects with an additional spectrum scaling. After which, the modified range doppler algorithm is derived for second order range compression and block-wise range cell migration correction. Raw data-based motion compensation is carried out with a doppler tracker. Squinted azimuth dependent phase gradient algorithm is employed to deal with azimuth dependent parameters and inexact deramping, with minimum entropy-based autofocusing algorithms. Finally, azimuth nonlinear chirp scaling is used for azimuth compression. Simulation and real data experiment results presented verify the effectiveness of the above signal processing approach.
31 July 2020 in IEEE Transactions on Geoscience and Remote Sensing
In conventional polar format algorithm (PFA), the effective imaging scene is bounded to a limited region near the reference point unless postprocessing is utilized. In a previous paper, refocusing and zoom-in PFA (RZPFA) for curvilinear spotlight SAR imaging were proposed to produce a refocused image for an arbitrary region of interest (ROI) with constant elevation. However, for certain applications, the residual distortion and defocus caused by rugged terrain could not be ignored. In this article, RZPFA is adapted to incorporate the known digital elevation model (DEM) into the imaging process, which is named as orthorectified PFA (OPFA). With just little additional computations than RZPFA, OPFA can realize georeferenced orthorectified imaging via a nonuniform fast Fourier transform of type 3 (NuFFT-3) without the need of postprocessing. The quantitative metrics for the residual DEM distortion and residual DEM defocus were also derived to determine the effective imaging extent of OPFA. Within the effective extent, the proposed OPFA can obtain an orthorectified image efficiently, and the image has a very high quality comparable to backprojection (BP). The imaging results of measured echo and DEM data demonstrated the effectiveness of the proposed algorithm.