The Crooked Lake area in Central Alberta, Canada, became seismically active in December 2013 with a sequence of earthquakes Mw 2.0 and higher. The earthquakes are suspected to be induced by hydraulic fracturing in nearby horizontal wells due to their strong spatiotemporal correlation. To investigate the physical mechanism of the induced seismicity near Crooked Lake, we calculate stress and pore pressure perturbations resulting from high‐rate multistage fluid injection in the framework of linear poroelasticity. The calculated perturbations are used for seismic risk analysis based on the Coulomb failure criterion. Results show that most seismicity is within a positive Coulomb stress change regime, indicating that failure is promoted by injection of fluid. By comparing Coulomb stress results for different parameter settings, we show that elastic response of the solid matrix, instead of fluid diffusion, is more likely the dominant factor for the induced earthquakes shortly after fluid injection.
25 June 2020 in Journal of Geophysical Research: Solid Earth
The 2017 Mw 5.5 Pohang earthquake in South Korea, the first reported and largest magnitude‐induced earthquake, occurred near the enhanced geothermal power plant in Pohang on 15 November 2017. We compute the spatiotemporal changes in poroelastic stresses perturbed by injected fluid under various conditions to better understand the occurrences of the Pohang earthquake and the small‐magnitude earthquakes preceding it. Space‐time variation of the earthquakes that occurred before the Pohang earthquake correlates significantly with fluid injection history between January 2016 and September 2017. We attribute the timing in earthquake occurrence to slow fluid diffusion, making hydraulic diffusivity of bedrock the critical model parameter for representing this slow process. In this context, the delay between the injection and the Pohang earthquake requires diffusivity estimates within a range of 1 × 10−4–5 × 10−4 m2/s for damaged granodiorite at 4–5 km, corresponding to the depth range between the well and the focal depth. According to these estimates, the pore pressure and thus the Coulomb failure stress changes are further enhanced by each injection with minimum stress dissipation. We find fluid injection can result in a change of the Coulomb stress of up to 0.4–1.1 bar, exceeding those associated with the 2016 Mw 5.5 Gyeongju earthquake by 2 orders of magnitude.
Over 100 small‐ to moderate‐sized earthquakes, including an Mw 5.0 event, were detected during September 2015 to November 2016 near the town of Cushing, Oklahoma. The seismic sequence was spatial‐temporally linked to four wastewater disposal wells within 4 km. We calculate pore pressure and stress perturbations caused by fluid injection at multiple wells and analyze seismic risk in a Coulomb failure stress framework. Despite being more than an order of magnitude smaller than the pore pressure perturbation, the sign of shear stress change, in the sense of assumed right‐lateral fault motion, dictates where earthquakes are induced. Most of the relocated earthquakes are located within areas of positive shear stress changes. Our results suggest that poroelastic stress changes also play an essential role in the wastewater disposal environment, and a strategic design of well locations with respect to fault orientation and direction of motion can help mitigate induced seismic hazard.
15 September 2022 in Geophysical Journal International
SUMMARY: Abnormal seismic activities near reservoirs usually show a strong spatiotemporal correlation with the water filling history. Reservoir-induced seismicity is thought to be related to crustal pore pressure and stress changes caused by water impounded behind the dams. Though the Coulomb-type stress analysis helps illuminate areas that would be under risk following reservoir impoundment, it lacks the ability to explain the temporal characteristics of reservoir-induced seismicity. We present a numerical investigation of the seismicity rate evolution of reservoir-induced earthquakes. Our modelling employs a fully coupled 2-D poroelastic model to calculate the pore pressure and stress changes caused by water impoundment and incorporates the rate- and state-dependent friction law to investigate the seismicity rate. We demonstrate that shallow earthquakes are mainly caused by pore pressure increase, while poroelastic stress transfer takes the dominant role at depth. Whether a fault would be brought close to failure depends on its geometrical properties and its relative location to the reservoir. The temporal evolution of reservoir-induced earthquakes is primarily controlled by tectonic environment instead of the diffusion of pore pressure.
The assessment of seismic risk and the prevention of earthquake occurrences during reservoir operation present significant challenges in terms of accurate determination. This study aims to address this issue by developing a numerical model. The primary objective is to estimate the vulnerability of different fault types to reservoir impoundment. This model integrates essential parameters such as fault dip and the relative orientation between the reservoir and potential earthquakes, and it is structured within a risk framework using polar coordinates. Through comprehensive computations, we evaluate the alterations in elastic stress and fluid pore pressure resulting from water impoundment. This is achieved by employing a fully coupled two-dimensional poroelastic approach. Furthermore, our model incorporates relevant seismic data to enhance its accuracy. The findings of our study underscore that the critical factor lies in the fault’s precise positioning with respect to the reservoir. The risk associated with a fault is contingent upon both its location and its orientation, emphasizing the importance of these factors in determining hazardous zones.
The absence of on-site monitoring measures or witnesses has delayed catastrophic landslide relief in remote areas. Recent advancements have revealed that existing seismic networks can record seismic signals generated by large landslides, which holds potential for predicting landslides. Nevertheless, automatically recognizing these landslide events from enormous seismic recordings is still challenging. Here, we develop an automatic recognition model using a particle swarm optimization-optimized random forest algorithm that automatically scans continuous seismic recordings within a 200 s window and identifies landslide events within 1.013 s, with an accuracy exceeding 98%. Our results demonstrate that stations within an epicentral distance of 250 km are more sensitive in recording landslide-generated seismic signals. Our work delivers the potential for a timely disaster response to catastrophic landslides in remote mountainous areas. Key findings also suggest the model’s potential to capture events preceding the main landslide event.