Lytic polysaccharide monooxygenase (LPMO) supports biomass hydrolysis by increasing saccharification efficiency and rate. Recent studies demonstrate that H₂O₂ rather than O₂ is the cosubstrate of the LPMO-catalyzed depolymerization of polysaccharides. Some studies have questioned the physiological relevance of the H₂O₂-based mechanism for plant cell wall degradation. This study reports the localized and time-resolved determination of LPMO activity on poplar wood cell walls by measuring the H₂O₂ concentration in their vicinity with a piezo-controlled H₂O₂ microsensor. The investigated Neurospora crassa LPMO binds to the inner cell wall layer and consumes enzymatically generated H₂O₂. The results point towards a high catalytic efficiency of LPMO at a low H₂O₂ concentration that auxiliary oxidoreductases in fungal secretomes can easily generate. Measurements with a glucose microbiosensor additionally demonstrate that LPMO promotes cellobiohydrolase activity on wood cell walls and plays a synergistic role in the fungal extracellular catabolism and in industrial biomass degradation.

In past years, new lytic polysaccharide monooxygenases (LPMOs) have been discovered as distinct in their substrate specificity. Their unconventional, surface-exposed catalytic sites determine their enzymatic activities, while binding sites govern substrate recognition and regioselectivity. An additional factor influencing activity is the presence or absence of a family 1 carbohydrate binding module (CBM1) connected via a linker to the C-terminus of the LPMO. This study investigates the changes in activity induced by shortening the second active site segment (Seg2) or removing the CBM1 from Neurospora crassa LPMO9C. NcLPMO9C and generated variants have been tested on regenerated amorphous cellulose (RAC), carboxymethyl cellulose (CMC) and xyloglucan (XG) using activity assays, conversion experiments and surface plasmon resonance spectroscopy. The absence of CBM1 reduced the binding affinity and activity of NcLPMO9C, but did not affect its regioselectivity. The linker was found important for the thermal stability of NcLPMO9C and the CBM1 is necessary for efficient binding to RAC. Wild-type NcLPMO9C exhibited the highest activity and strongest substrate binding. Shortening of Seg2 greatly reduced the activity on RAC and CMC and completely abolished the activity on XG. This demonstrates that Seg2 is indispensable for substrate recognition and the formation of productive enzyme-substrate complexes.

Laccase is predominantly found in lignin degrading filamentous white rot fungi, where it is involved in the oxidative degradation of this recalcitrant heteropolymer. In brown rot fungi it is much less prevalent: laccases from only a few brown rots have been detected and only two have been characterized. This study tries to understand the role of this ligninolytic enzyme in brown rots by investigating the catalytic properties of laccases secreted by Fomitopsis pinicola FP58527 SS1. When grown on either poplar or spruce wood blocks, several laccases were detected in the secretome. Two of them (FpLcc1 and FpLcc2) were heterologously produced using Trichoderma reesei QM9414 Δxyr1 as expression host and purified to homogeneity by consecutive steps of hydrophobic interaction, anion exchange and size exclusion chromatography. With the substrates 2,2-azino-bis(3-ethylthiazoline-6-sulfonate) (ABTS), 2,6-dimethoxyphenol (2,6-DMP) and guaiacol both laccases showed similar, low pH-optima below 3 for ABTS and 2,6-DMP and at pH 3.5 for guaiacol which is at the acidic end of laccases isolated from white rot fungi. The determined KM values were low while kcat values measured at acidic conditions were comparable to those reported for other laccases from white rot fungi. While both enzymes showed a moderate decrease in activity in the presence of oxalic and citric acid FpLcc2 was activated by acetic acid up to 3.7 times. This activation effect is much more pronounced at pH 5.0 compared to pH 3.0 and could already be observed at a concentration of 1 mM acetic acid.

Glyoxal oxidase (GLOX) is an extracellular source of H₂O₂ in white-rot secretomes, where it acts in concert with peroxidases to degrade lignin. It has been reported that GLOX requires activation prior to catalytic turnover and that a peroxidase system can fulfill this task. In this study, we verify that an oxidation product of horseradish peroxidase, the radical cation of 2,2'-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid), is an activator for GLOX. A spectroelectrochemical cell was used to generate the activating radical species, to continuously measure its concentration, and to simultaneously measure the catalytic activity of GLOX based on its O₂ consumption. The results show that GLOX can undergo multiple catalytic turnovers upon activation and that activity increases with the activator concentration. However, we also found that the ABTS cation radical can serve as an electron acceptor which becomes visible in the absence of O₂. Furthermore, GLOX activity is highly restrained by the naturally occurring, low O₂ concentration. We conclude that GLOX is indeed an auxiliary enzyme for H₂O₂ production in white-rot secretomes. Its turnover rate is strongly regulated by the availability of O₂ and the radical generating activity of peroxidases present in the secretome, which acts as a feedback loop for GLOX activity.

In the secretome of Phanerochaete chrysosporium, a white-rot fungus serving as a model organism to elucidate lignocellulose deconstruction, the copper containing metalloprotein glyoxal oxidase (GLOX) is potentially involved in the crucial production of hydrogen peroxide to fuel and initiate oxidative biomass degradation by lignin-degrading peroxidases. Its ability to oxidize a variety of aldehydes and α-hydroxy carbonyls with the concomitant reduction of dioxygen to hydrogen peroxide has attracted attention for its application as green biocatalyst in different industrial fields. Here we report and compare two efficient processes for the heterologous production of GLOX from P. chrysosporium using the well-established methanolytic yeast Pichia pastoris and the filamentous fungus Trichoderma reesei as expression hosts with subsequent purification by anion exchange and hydrophobic interaction chromatography. Both processes were shown to be suitable for the production of the target protein at high levels. GLOX produced in T. reesei carries mainly Man5 glycosylation while the enzyme produced in P. pastoris exhibits the typical high-mannose type N-glycosylation. The enzyme expressed in P. pastoris showed slightly higher specific activities which correlates with the higher copper loading of 65.5 % compared to 51.9 % for the protein from T. reesei. The pH optimum for both recombinant proteins was 6.0, however, GLOX activity was found to be highly affected by different buffer species. Both enzymes showed very similar substrate affinities and turnover numbers with the highest catalytic efficiency observed for methylglyoxal. GLOX from both expression hosts is therefore a suitable enzyme for further mechanistic characterization and application studies.