In the present article, six symmetric compound parabolic solar concentrators (CPCs) with all-glass evacuated solar tubes (EST) as the receiver are designed, and a comparative study on their optical performance is performed based on theoretical analysis and ray-tracing simulations. In terms of optical loss through gaps of CPCs and optical efficiency averaged for radiation over the acceptance angle, CPC-6, designed based on a fictitious “hat”-shaped absorber with a “V” groove at the bottom, is the optimal design, and CPC-1, designed based on the cover tube, is the worst solution, whereas from the point of view of the annual collectible radiation on the EST, it is found that CPC-4, designed based on a fictitious “ice-cream” absorber, is the optimal design and CPC-1 is the worst solution. CPC-6, commonly regarded as the best design in the past, is not an optimal design in terms of annual collectible radiation after truncation. Results also indicate that, for high temperature applications, CPC-6 and CPC-4 are advisable due to the high solar flux on the EST resulting from the high optical efficiency for radiation within the acceptance angle.
In this article, the performance of an inclined north-south axis (INSA) multiple positions sun-tracked V-trough with restricted reflections for photovoltaic applications (MP-VPVs) is investigated theoretically based on the imaging principle of mirrors, solar geometry, vector algebra and three-dimensional radiation transfer. For such a V-trough photovoltaic module, all incident radiation within the angle arrives on solar cells after less than k reflections, and the azimuth angle of V-trough is daily adjusted M times about INSA to ensure incident solar rays always within in a day. Calculations and analysis show that two-dimensional sky diffuse radiation can’t reasonably estimate sky diffuse radiation collected by fixed inclined north-south V-trough, but can for MP-VPVs. Results indicate that, the annual power output (Pa) of MP-VPVs in a site is sensitive to the geometry of V-trough and wall reflectivity (ρ), hence given M, k and ρ, a set of optimal and , the opening angle of V-trough, for maximizing Pa can be found. Calculation results show that the optimal is about 21°, 13.5° and 10° for 3P-, 5P- and 7P-VPV-k/ (k = 1 and 2), respectively, and the optimal for maximizing Pa is about 30° for k = 1 and 21° for k = 2when ρ > 0.8. As compared to similar fixed south-facing PV panels, the increase of annual electricity from MP-VPVs is even larger than the geometric concentration of V-trough for ρ > 0.8 in sites with abundant solar resources, thus attractive for water pumping due to stable power output in a day.
1 November 2019 in Journal of Renewable and Sustainable Energy
In this article, the photovoltaic (PV) and sun-tracking performance of single-axis multiposition sun-tracking PV panels (MP-PV) is investigated based on solar geometry and dependence of PV conversion efficiency on the incident angle of solar rays on PV panels. For such PV systems, the azimuth angle of the PV panels is adjusted daily M times from an eastward direction in the morning to a westward direction in the afternoon by rotating the PV panels about the inclined north–south axis (INSA) to ensure that the projected incident angle (PIA) of solar rays on the plane perpendicular to the INSA is always less than the angle θa, the specified maximum PIA. Results show that the annual average sun-tracking efficiency ( ) and the annual electricity generation (AEG) of the MP-PV system increase as M increases, but this increase is less than 1% when M > 5. The optimal θa of the MP-PV system for maximizing AEG and the ratio (Cp,MP-0) of AEG of the optimized MP-PV system to that of a similar fixed PV system are highly dependent on the annual average atmospheric clearness index (Kt) but only slightly dependent on the site latitude (λ). For an MP-PV with a tilt angle (β) of the INSA that is fixed yearly, the AEG of 3P-, 5P-, and 7P-PV systems is about 92%, 94%, and 95%, respectively, of that obtained from a similar dual-axis tracking PV panel (2A-PV). However, for an MP-PV whose β is adjusted four times a year at three tilts, the AEG of 3P-, 5P-, and 7P-PV systems is about 96%, 98%, and 99%, respectively, of that of a similar 2A-PV system. Empirical correlations for quick estimation of the optimal θa and Cp,MP-0 of the MP-PV optimized for maximizing AEG are suggested and examined based on monthly global radiation on the horizon at 30 sites around China.
In the past, two-dimensional radiation transfer models (2-D models) were widely used to investigate the optical performance of linear compound parabolic concentrators (CPCs), in which the radiation transfer on the cross-section of CPC troughs is considered. However, the photovoltaic efficiency of solar cells depends on the real incidence angle instead of the projection incidence angle, thus 2-D models can’t reasonably evaluate the photovoltaic performance of CPC-based photovoltaic systems (CPVs). In this work, three-dimensional radiation transfer (3-D model) within CPC-θa/θe, the CPC with a maximum exit angle θe for radiation within its acceptance angle (θa), is investigated by means of vector algebra, solar geometry and imaging principle of plane mirror, and effects of geometry of CPV-θa/θe on its annual electricity generation are studied. Analysis shows that, as compared to similar photovoltaic (PV) panels, the use of CPCs makes the incident angle of solar rays on solar cells increase thus lowers the photovoltaic conversion efficiency of solar cells. Calculations show that, 2-D models can reasonably predict the optical performance of CPVs, but such models always overestimate the photovoltaic performance of CPVs, and even can’t predict the variation trend of annual power output of CPV-θa/θe with θe. Results show that, for full CPV-θa/θe with a given θa, the annual power output increases with θe first and then comes to a halt as θe > 83°, whereas for truncated CPV-θa/θe with a given geometric concentration (Ct), the annual power output decreases with θe.