Aero-servo-elastic analyses are required to determine the wind turbine loading for a wide range of load cases as specified in certification standards. The floating reference frame (FRF) formulation can be used to model the structural response of long and flexible wind turbine blades. Increasing the number of bodies in the FRF formulation of the blade increases both the fidelity of the structural model and the size of the problem. However, the turbine load analysis is a coupled aero-servo-elastic analysis, and computation cost not only depends on the size of the structural model, but also depends on the aerodynamic solver and the number of iterations between the solvers. This study presents an investigation of the performance of the different fidelity levels as measured by the computational cost and the turbine response (e.g., blade loads, tip clearance, tower-top accelerations). The analysis is based on aeroelastic simulations for normal operation in turbulent inflow load cases as defined in a design standard. Two 10 MW reference turbines are used. The results show that the turbine response quickly approaches the results of the highest-fidelity model as the number of bodies increases. The increase in computational costs to account for more bodies can almost entirely be compensated for by changing the type of the matrix solver from dense to sparse.
20 March 2018 in Journal of Solar Energy Engineering
This paper presents a comprehensive study of the evaluation of the effect of spar cap fiber orientation angle of composite blades with induced bending–torsion coupling (IBTC) on the aero-structural performance wind turbines. Aero-structural performance of wind turbines with IBTC blades is evaluated with the fatigue load mitigation in the whole wind turbine system, tower clearances, peak stresses in the blades, and power generation of wind turbines. For this purpose, a full E-glass/epoxy reference blade has been designed, following the inverse design methodology for a 5-MW wind turbine. An E-glass/epoxy blade with IBTC and novel, hybrid E-glass/carbon/epoxy blades with IBTC have been designed and aeroelastic time-marching multibody simulations of the 5-MW turbine systems, with the reference blade and the blades with IBTC, have been carried out using six different randomly generated turbulent wind profiles. Fatigue-equivalent loads (FELs) in the wind turbine have been determined as an average of the results obtained from the time response of six different simulations. The results reveal that certain hybrid blade designs with IBTC are more effective in fatigue load mitigation than the E-glass–epoxy blade with IBTC, and besides the fiber orientation angle, sectional properties of hybrid blades must be adjusted accordingly using proper number of carbon/epoxy layers in the sections of the blade with IBTC, in order to simultaneously reduce generator power losses and the FEL.
Most small–medium-sized turbine studies have focused on presenting new design methods and corresponding performance improvements rather than detailed dynamic investigations. This paper presents comprehensive dynamic investigations of a straight and a swept-back blade for a 100 turbine by performing modal analysis, dynamic load analysis, and flutter analysis. The considered load cases include steady wind and operational conditions under normal and extreme turbulence. Modal results show that although both blades have similar natural frequencies, their mode shapes are quite different due to the couplings in flapwise-torsion directions introduced by the back-swept geometry. This coupling alters the aeroelastic response of the blade, which results in different loads in the operational conditions. The load analysis results show that the blade damage equivalent fatigue loads for the swept blade are much lower (up to 29% for the flapwise bending moment and 31% for the edgewise bending moment) than the straight blade. For the ultimate loads, blade root edgewise load for the swept blade is almost 50% lower than the straight blade while the flapwise ultimate load is similar for both blades. Moreover, both blades have no aeroelastic instability near the operational conditions, and the flutter limit for the swept-back blade is lower than the straight blade.
16 June 2014 in Journal of Physics: Conference Series