This paper presents a microfluidic chemical reaction using an electrowetting-on-dielectric (EWOD) digital microfluidic device. Despite a number of chemical/biological applications using EWOD digital microfluidic devices, their applications to organic reactions have been seriously limited because most of the common solvents used in synthetic organic chemistry are not compatible with EWOD devices. To address this unsolved issue, we first introduce a novel technique using an “engine-and-cargo” system that enables the use of non-movable fluids (e.g., organic solvents) on an EWOD device. With esterification as the model reaction, on-chip chemical reactions were successfully demonstrated. Conversion data obtained from on-chip reactions were used to characterize and optimize the reaction with regard to reaction kinetics, solvent screening, and catalyst loading. As the first step toward on-chip combinatorial synthesis, parallel esterification of three different alcohols was demonstrated. Results from this study clearly show that an EWOD digital microfluidic platform is a promising candidate for microscale chemical reactions.

In electrowetting-on-dielectric (EWOD) microfluidics, a motion of a fluid is created by a voltage applied to the fluid/surface interface. Water and aqueous solutions are the most frequently used fluids in EWOD devices. In order for EWOD microfluidics to be a versatile platform for various applications, however, movability of different types of fluids other than aqueous solutions should be understood. An electromechanical model using a simple RC circuit has been used to predict the mechanical force exerted on a liquid droplet upon voltage application. In this present study, two important features missed in previous works are addressed. Energy dissipation by contact line friction is considered in the new model as the form of resistor. The phase angle is taken into account in the analysis of the AC circuit. The new electromechanical model and computation results are validated with experimental measurements of forces on two different liquids. The model is then used to explain influences of contact angle hysteresis, surface tension, conductivity, and dielectric constant of fluids to the mechanical force on a liquid droplet.

Uterine fibroids represent the highest prevalence of benign tumors in women, with reports ranging from 4.5% to 68.6%, with a significant bias towards African American women. For uterine fibroids, a significant decision is determining whether fibroids can be successfully removed using minimally invasive (MI) techniques or their removal requires open surgery. Currently, the standard-of-care for intra-procedural visualization for myomectomies is ultrasound, which has low image quality and requires a specially trained assistant. Currently, the state-of-the-art is to obtain a pre-procedural MRI scan of the patient, which can be used for diagnosis and pre-procedural planning. Although proven incredibly useful pre-procedurally, MRI scans are not often used intra-procedurally due to the inconvenient visualization as 2D slices, which are seen on 2D monitors that do not intuitively convey the depth or orientation of the fibroids, as needed to effectively perform myomectomies. To address this limitation, herein, we present the use of a mixed reality headset (i.e., Microsoft HoloLens 2), as a tool for intra-procedural image-guidance during a mock myomectomy of an ex vivo animal uterus. In this work, we created a patient-specific holographic rendering by performing image segmentation of an MRI scan of a custom-made uterine fibroid animal model. A physician qualitatively assessed the usefulness of the renderings for fibroid localization, as compared to the same visualization on a 2D monitor. In conclusion, the use of mixed reality as an intra-procedural image guidance tool for myomectomies was perceived as a better visualization technique that could lead to improvements in MI approaches and make them accessible to patients from lower socioeconomic populations.