This article described project of fuzzy logic controller witch control the scope of opening cowl flaps in Piper Seneca V engines. This allows to maintain optimum engine temperature by varying the amount of air flow through the engine compartment. The main task of controller is to reduce pilot workload during the entire flight, as well as to maintain optimum engine operating parameters in order to increase its service life. The designed fuzzy controller generates a cowl flaps control signal according to the three most important input parameters: Cylinder Head Temperature (CHT), Vertical Speed Indicator (VSI), Manifold Pressure (MP). The project uses Matlab and Fuzzy Logic Toolbox software. The authors presented the performance of the system based on twenty samples for research, which simulate position flaps. This articles presented also control surfaces, due to which it is possible to analyze controller performance. At the end showed the simulation process in the Simulink software package with the preset input values.
This paper is a continuation of research into the possibility of using fuzzy logic to assess the reliability of a selected airborne system. The research objectives include an analysis of statistical data, a reliability analysis in the classical approach, a reliability analysis in the fuzzy set theory approach, and a comparison of the obtained results. The system selected for the investigation was the aircraft gun system. In the first step, after analysing the statistical (operational) data, reliability was assessed using a classical probabilistic model in which, on the basis of the Weibull distribution fitted to the operational data, the basic reliability characteristics were determined, including the reliability function for the selected aircraft system. The second reliability analysis, in a fuzzy set theory approach, was conducted using a Mamdani Type Fuzzy Logic Controller developed in the Matlab software with the Fuzzy Logic Toolbox package. The controller was designed on the basis of expert knowledge obtained by a survey. Based on the input signals in the form of equipment operation time (number of flying hours), number of shots performed (shots), and the state of equipment corrosion (corrosion), the controller determines the reliability of air armament. The final step was to compare the results obtained from two methods: classical probabilistic model and fuzzy logic. The authors have proved that the reliability model using fuzzy logic can be used to assess the reliability of aircraft airborne systems.
The article discusses the aerodynamic properties of the Guimbal Cabri G2 helicopter. The main considerations concern the helicopters ascending to the altitude under initial conditions, which were assumed in the project and how the change of the defuzzification method affects the work of the fuzzy controller. The authors analyzed the following: the aircraft, the crew and the payload. The authors assessed the altitude and the minimum time of the helicopter climb. In designing and the work simulation process, the authors used Matlab and Simulink software. A comparison of the influence of selected defuzzification methods on the work of the fuzzy controller was made.
The paper attempts to present the current state of knowledge in the use of fuzzy logic in order to assess the reliability of technical objects over the past two decades. In world literature, one can recall three main trends related to the use of fuzzy logic in the reliability estimation. The first one deals mainly with an analysis and assessment of the risk of failure. In the second mainstream, the researchers try to analyse the human factor, which also influences system malfunction. The third group of reliability studies the possibility of using fuzzy logic for proper service planning and thus preventing damage. In each of the three mentioned trends, fuzzy logic complements the classic methods of estimating and predicting reliability.