Reliability is one of the most important requirements for electric motor installations. Bearing assembly is a common source of failure for most electric motors. One of the main reasons for such failures is the wear of the bearing seat of the end shield. This paper presents a combined technology for increasing the durability of the bearing bores of electric motor bearing shields made of aluminum alloys. The technological concept is that a worn-out end-shield bore is firstly restored by supersonic gas-dynamic spraying, and secondly, in order to improve anti-wear properties, it is strengthened by micro-arc oxidation. The adhesion of coatings has been studied, and the wear resistance of the formed coatings has been evaluated. Based on the performed studies, it can be assumed that the service life of the bearing assembly of an electric motor restored by gas-dynamic spraying with the novel technology of micro-arc oxidation in real operating conditions will increase on average by 3–4 times. The developed technology is recommended for repair, maintenance, or other technical services dealing with the restoration and hardening of worn-out parts.
1 June 2021 in Journal of Physics: Conference Series
The use of LEDs in lamps is promising for effective plant growth. Plant growth lamps are designed to create artificial lighting for agricultural crops. This work is devoted to the creation of a smart LED lamp with the ability to adjust the spectral composition of radiation depending on the stage of growth and the type of plant. A number of experiments were carried out to investigate the effect of various radiation parameters on the growth characteristics of dill, parsley, green onion and cucumber seeds. The optimal radiation parameters that contribute to the acceleration of the selected model plants growth were identified. Based on the results obtained, a multi-wavelength LED lamp with an adjustable radiation composition, including blue 440 nm and red 660 nm LEDs, was developed. In the lamp, the possibility of changing the spectral composition of radiation at different stages of growth was realized. Therefore, it is possible to change the light parameters in accordance with the obtained data on the development of crops.
11 September 2021 in Fullerenes, Nanotubes and Carbon Nanostructures
The paper presents the results of experimental studies in the scope of formation of bulky aluminum based composite materials (CM) with carbon nanofibers (CNF), including the research methods of hot extrusion and rolling. Extrusion manufacture of bulky composite materials contributes to obtain billets with a minimum compression degree (λ = 1.5). To reduce shear deformations and formation of pores in extruded billet, the extrusion process modes were selected experimentally. In the course of further rolling operation, mechanical properties increase twice and inhomogeneity is compensated after significant compression of the extrusion billets, and the shear deformations are reduced in full volume of the material. Bulky materials gain high hardness, wear resistance and strength. The economically alloyed composite material has feasible prospects to be applicable in lightweight structures for aviation and automobile industries.
A shielding system on the basis of MAP-1K rolled magnetic material was simulated and made, and is designed to protect photomultiplier tubes integrated in new neutrino detectors under NEUTRINE-4M experiment against Earth’s magnetic field. Shielding coefficient was calculated for an individual cylindrical shield and assembly of 25 shields with the shielding structure axis directed along or across Earth’s horizontal magnetic field. The obtained experimental data was compared with computer simulated data. Features of interaction between the shields in the system were examined. It was demonstrated that there is virtually no Earth’s magnetic field effect on the detector performance when the detector is moved and rotated in the experiment with a new neutrino detector furnished with magnetic shields.