Fast, continuous, 3D printing: Although three-dimensional (3D) printing is now possible using relatively small and low-cost machines, it is still a fairly slow process. This is because 3D printers require a series of steps to cure, replenish, and reposition themselves for each additive cycle. Tumbleston et al. devised a process to effectively grow solid structures out of a liquid bath. The key to the process is the creation of an oxygen-containing “dead zone” between the solid part and the liquid precursor where solidification cannot occur. The precursor liquid is then renewed by the upward movement of the growing solid part. This approach made structures tens of centimeters in size that could contain features with a resolution below 100 µm. Science , this issue p. 1349
1-D ZnO nanorods with different aspect ratios were synthesized by a one-step, hydrothermal method. The ZnO nanorods grow along the [0001] direction to form single crystals. The experimental results reveal that the growth of polar inorganic crystals is sensitive to the reaction solvents.
We report a replication route to non-planar, three dimensional microlens arrays with an antireflective surface nanopattern. Our methodology uses the surface topography of the Attacus atlas moth's compound eye and a soft lithographic technique to fabricate topographically faithful moulds that, in turn, are used to reproducibly replicate the original eye surface with nanoscale fidelity. In addition to antireflection, the resulting poly(urethane) replica with its “moth-eye” nanopattern also exhibits increased hydrophobicity relative to the unpatterned polymer. The materials flexibility of the perfluoropolyether mould fabricated viareplica moulding enables, for example, the embossing of antireflective nanopatterns in the photoactive materials of organic solar cells.
We review nano-structures used as light trapping schemes in organic photovoltaic (OPV) cells. Light management via nano-structures enables one to exploit sub-diffraction limit properties, thereby giving access to enhanced light absorption in OPV cells. Light trapping schemes have been demonstrated in the form of surface plasmons, anti-reflection coatings, and photonic crystal patterns. Versatile methods are now available to facilitate fabrication of such nano-structures on sufficiently large areas for OPV applications.
In 1970, two seemingly unrelated reports about nematic liquid crystals appeared in the scientific literature: at Kent State University, Adrian de Vries reported local smectic order in a nematic that he termed cybotactic, and at IBM, Marvin Freiser showed the possibility of a lower symmetry nematic that he named biaxial. These two discoveries are connected through consideration of the origins of spontaneous symmetry breaking, in particular, how broken symmetry within transient clusters permeating a nominally uniaxial nematic may lead to a biaxial nematic.
Photoluminescence from zinc oxide (ZnO) nanoparticles, nanorods, microparticles, and single crystals was measured under various conditions of ultraviolet excitation. Near-band-gap and deep-level emissions were observed from all samples. The intensities of both emissions from each ZnO sample exhibited a different nonlinear dependence on the excitation density. These differences could be interpreted by the variation of the light scattering and the specific surface areas of the ZnO morphologies. The intensity ratio of the near-band-gap emission to the deep-level emission from the ZnO samples strongly depended on the density of the excitation light. Our results indicated that the intensity ratio of two emissions depends on the sample type (such as the dimension, specific surface area, etc.), as well as the experimental conditions (such as excitation density, radiation area, etc.). Therefore, this ratio could not be simply employed to unequivocally evaluate the quality of the ZnO.