The influence of temperature, CO₂ concentration and relative humidity on the carbonation depth and compressive strength of concrete was investigated. Meanwhile, phase composition, types of hydration products and microstructure characteristics of samples before and after the carbonation were analyzed by XRD and ESEM. Research results demonstrate that temperature, CO₂ concentration and relative humidity influence the carbonation depth and compressive strength of concrete significantly. There is a linear relationship between temperature and carbonation depth, as well as the compressive strength of concrete. CO₂ concentration and relative humidity present a power function and a polynomial function with carbonation depth of concrete, respectively. The concrete carbonation depth increases with the increase of relative humidity and reaches the maximum value when the relative humidity is 70%. Significant differences of phase composition, hydration products and microstructure are observed before and after the carbonation. Carbonization products of samples are different with changes of temperatures (10 °C, 20 °C and 30 °C). The result of crystal structure analysis indicates that the carbonation products are mainly polyhedral spherical vaterite and aragonite.

Adding basalt fiber to concrete can improve the mechanical properties of concrete, and it is also one of the best ways to enhance the ultimate bearing capacity of concrete structure. In this paper, the construction performance and the compressive strength of basalt-fiber-reinforced concrete (BFRC) with five kinds of fiber lengths and eight kinds of fiber volume content subjected to an axial load are systematically investigated. The optimum fiber length and fiber volume content are obtained by comprehensively considering the construction performance and compressive strength. Moreover, the prediction model and finite element analysis method of the ultimate bearing capacity of basalt-fiber-reinforced concrete are developed. The results show that the optimum fiber length is about 12–24 mm and the fiber volume content is 0.15%. Adding an appropriate amount of basalt fiber can effectively improve the ultimate bearing capacity of concrete short columns, with maximum and average increases of 28% and 24%, respectively. In addition, the comparison with the experimental results shows that both the proposed prediction method and the finite element modeling method have good applicability, and they can be used to predict the ultimate bearing capacity of the BRFC short columns in practical engineering.

The effects of the type and content of fibers, water to cement ratio (W/C), and content of cementitious materials on the shrinkage and creep of ultra-high performance concrete (UHPC) were investigated. The relationships between curing age, shrinkage, and unit creep of the UHPC were also discussed. The results showed that the shrinkage of the UHPC decreased with the increase in W/C, where there existed a quadratic function between shrinkage and W/C. However, the unit creep of the UHPC increased with W/C. The shrinkage and unit creep of the UHPC increased with the increase in the content of the cementitious materials. The type and content of fibers had different effects on the shrinkage and unit creep of the UHPC, that is, the shrinkage of the UHPC first increased and then decreased with the increase in the content of steel fibers, where there existed a quadratic function between them. There was a linear function between the shrinkage of the UHPC and the content of carbon fibers, but the shrinkage of the UHCP first increased and then decreased with the increase in PVA content. The shrinkage and unit creep of the UHPC at the initial curing age were significant, which tended to be constant with the increase in curing age. Although the steel fibers had a significant inhibiting effect on the unit creep of the UHPC, the carbon fibers and PVA had positive and negative effects on the unit creep of the UHPC. The effects of the type and content of fibers on the shrinkage and unit creep of the UHPC were caused by the slenderness ratio, shape, surface roughness, and elasticity modulus of the fibers. The shrinkage and creep of the UHPC were caused by the chemical autogenous shrinkage and free water evaporation of the UHPC.