Pure, and doped with Al/Mn, ZnO nanoparticles were produced by the chemical co-precipitation method. X-ray diffraction analysis confirmed the hexagonal crystalline with wurtzite structure of pure and doped samples. Williamson-Hall (W-H) analysis was used to determine the crystallite size and micro-strains. The change in the bond length and lattice parameters of the doped ZnO confirms the incorporation of Al3+ ions to interstitial sites and Mn2+ ions to substitutional sites of ZnO lattice. UV-Visible spectroscopy has been used to study the change in the absorption edge after doping. Dielectric and conducting properties have been investigated and compared. Dielectric properties of doped samples have indicated the hopping mechanism liable for the change. Dielectric loss (tanδ) shows the opposite direction with frequency due to dielectric dispersion. The ac conductivity also indicated their variation after doping and is associated with an increase in the charge carrier and defects, which ultimately decides the overall change.
The primary aim was to study the doping effect of Zn in MgO nanoparticles (NPs) prepared by the co-precipitation method. X-ray diffraction (XRD) results inferred the cubic structure of MgO with good crystallinity, which changed with dopant additions. Scanning electron microscope (SEM) images exposed the development of NPs with decreasing size and dimensions with little agglomeration on doping. Fourier transform infrared (FTIR) results revealed the Mg-O bond formation, which is associated with Zn-O bond on increasing dopant content. UV Vis studies showed the red shift in absorption edge and decreased band gap with percentage of Zn dopant additions. The dielectric results exposed the dielectric constant, dielectric loss and ac conductivity of Zn-doped MgO NPs. Dopant addition led to the higher dielectric constant and low dielectric loss at lower frequency due to oxygen vacancies generation. The impedance behaviour in different frequency regimes illustrated the effective contribution of conductive grains and insulating grain boundaries.
Pure and Cu/Ag co-doped ZnO nanoparticles were synthesised by the co-precipitation method. The phase and structural analysis of ZnO nanoparticles were examined by using XRD and Williamson-Hall plots. XRD spectra revealed that prepared samples exhibit hexagonal wurtzite structure of ZnO. The change in lattice parameters, bond length, dislocation density and strain indicates that Cu and Ag were successfully incorporated. UV vis studies indicated the red shift in the absorption band attributed to defects induced after dopant additions. The dielectric measurements showed that the dielectric constant was found to increase and the dielectric loss decreases with increase in dopant percentage. Additions of Cu and Ag in ZnO lattice may lead to supplement grain boundary defects which can increase polarisation. The relatively higher values of ac conductivity were also found due to modulation of charge carrier density after dopant additions which suggest that the diffusion controlled charge carrier hopping mechanism is involved.