In flexi-grid optical networks, fragmentation of spectrum resources may significantly affect the overall network efficiency. Effective techniques for defragmentation (i.e., re-optimization) are then required to limit the wasting of spectrum resources. However, current defragmentation techniques can only be implemented thanks to the presence of additional resources, such as spare expensive transponders. In this study, we propose, discuss and evaluate a novel defragmentation technique called push-pull. The technique is based on dynamic lightpath frequency retuning upon proper reconfiguration of allocated spectrum resources. It does not require additional transponders and does not determine traffic disruption. All the relevant technological limitations that may affect the push-pull applicability are discussed in the context of both optically-amplified direct and coherent detection systems. The technique is then successfully demonstrated in two different flexi-grid network testbeds, reproducing the two aforementioned scenarios. In particular, the reoptimization of a 10 Gb/s OOK lightpath is safely completed in few seconds (mainly due just to node configuration latencies) without experiencing any traffic disruption. Similarly, the push-pull is successfully performed on a 100 Gb/s PM-QPSK lightpath, providing no traffic disruption.

Accurate real-time availability of transmission parameters at the network controller has the potential to significantly improve the efficiency of control and management operations, particularly in the case of soft failures where detection and localization procedures are typically affected by the long monitoring time intervals usually adopted in current Elastic Optical Networks (EONs). In this paper, we report on the design, implementation and experimental demonstration of a telemetry service exploiting the gRPC protocol to enable on-demand streaming of real-time monitoring parameters, dynamically retrieved from a configurable set of network devices. The telemetry service is efficiently introduced for Software Defined Networking in EONs, also accounting for disaggregated network elements through standard YANG-defined network models. The implemented telemetry service is experimentally validated for partial and fully disaggregated architectures over networking scenarios where soft failures not addressable through traditional monitoring solutions are successfully detected and localized. Moreover, detailed performance evaluation is conducted varying the number of subscribed network elements, the type of communication (e.g., compressed vs. uncompressed, bundled vs. unbundled), showing remarkable scalability performance particularly in the case of compressed and bundled telemetry configurations.

Quality of Service-enabled applications and services rely on Traffic Engineering-based (TE) Label Switched Paths (LSP) established in core networks and controlled by the GMPLS control plane. Path computation process is crucial to achieve the desired TE objective. Its actual effectiveness depends on a number of factors. Mechanisms utilized to update topology and TE information, as well as the latency between path computation and resource reservation, which is typically distributed, may affect path computation efficiency. Moreover, TE visibility is limited in many network scenarios, such as multi-layer, multi-domain and multi-carrier networks, and it may negatively impact resource utilization. The Internet Engineering Task Force (IETF) has promoted the Path Computation Element (PCE) architecture, proposing a dedicated network entity devoted to path computation process. The PCE represents a flexible instrument to overcome visibility and distributed provisioning inefficiencies. Communications between path computation clients (PCC) and PCEs, realized through the PCE Protocol (PCEP), also enable inter-PCE communications offering an attractive way to perform TE-based path computation among cooperating PCEs in multi-layer/domain scenarios, while preserving scalability and confidentiality. This survey presents the state-of-the-art on the PCE architecture for GMPLS-controlled networks carried out by research and standardization community. In this work, packet (i.e., MPLS-TE and MPLS-TP) and wavelength/spectrum (i.e., WSON and SSON) switching capabilities are the considered technological platforms, in which the PCE is shown to achieve a number of evident benefits.

Next-generation edge nodes interfacing innovative IT clusters, 5G fronthaul, and internet of things (IoT) gateways to the optical metro/core network will require advanced and dynamic online quality of service (QoS) per-flow traffic treatment, assuring ultra-low latency requirements. However, current software-defined networking (SDN) implementations (e.g., OpenFlow) do not support forwarding procedures based on the network state, profile variations, and the history of flow statistics at the node level. Currently, such procedures require intervention by the SDN controller, leading to scalability issues and additional latency in data plane forwarding. Moreover, severe security challenges are expected to affect such nodes and threaten IT resources. Thus, increasing bandwidths will require direct deep packet inspection to avoid involvement of the SDN controller, as performed currently, or dedicated and costly security systems. This paper leverages on the potential of the programming protocol-independent packet processors (P4) open source language, recently introduced by the inventors of OpenFlow, to program the data plane structure and behavior of an SDN switch. P4 is able to instantiate custom pipelines and stateful objects, enabling complex workflows, user-defined protocols/headers, and finite state machines enforcement. Moreover, P4 allows portable implementations over different hardware targets, thus opening the way to open source fully programmable devices. Special effort is dedicated to motivate and apply P4 within a multilayer edge scenario, proposing the architecture and the applicability of an SDN P4-enabled packet-over-optical node. Moreover, three specific multilayer use cases covering dynamic traffic engineering (TE) (e.g., traffic offload and optical bypass) and cybersecurity (e.g., distributed denial of service port scan) are discussed and addressed through P4-based solutions. Experimental evaluations have been conducted over a multilayer SDN network exploiting reference P4 software switches (i.e., the behavioral model version 2, or BMV2) and field-programmable gate arrays (FPGAs) at 10 gigabit Ethernet optical interfaces. Extensive results report effective dynamic TE and cybersecurity mitigation enforcement at P4 switches without any controller intervention, showing excellent scalability performance and overall latencies practically in line with current commercial OpenFlow switches.

Flexible optical networks, based on bandwidth-variable optical cross-connects (BV-OXCs) and novel flexible transponders, are expected to significantly improve the overall spectrum efficiency with respect to traditional networks where fixed frequency spacing is applied. Flexible optical networks will exploit the BV-OXC capability to dynamically configure the reserved bandwidth as a set of frequency slots. In addition, flexible transponders will be employed to dynamically configure transmission parameters, such as bit-rate and modulation format. To enable these new configuration capabilities, network operation enhancements need to be efficiently introduced and investigated. In this study, we focus for the first time on the Path Computation Element (PCE) architecture for flexible optical networks. PCE architecture and PCE communication protocol are enhanced to maximize the spectral efficiency and to provide indications also on the specific transmission parameters to configure. Experimental demonstration is provided through two different experiments, successfully showing the PCE capability to trigger dynamic rerouting with bit-rate or modulation format adaptation. In particular, the experiments demonstrate, in a real testbed, dynamic frequency slot assignment and format adaptation from DP-16QAM to DP-QPSK at 100 Gb/s, and bit-rate adaptation at DP-16QAM from 200 Gb/s to 100 Gb/s.

Next generation optical networks will require high levels of flexibility both at the data and control planes, being able to fit rate, bandwidth, and optical reach requirements of different connections. Optical transmission should be able to support very high rates (e.g., 1 Tb/s) and to be distance adaptive while optimizing spectral efficiency (i.e., the information rate transmitted over a given bandwidth). Similarly, the control plane should be capable of performing effective routing and spectrum assignment as well as proper selection of the transmission parameters (e.g., modulation format) depending on the required optical reach. In this paper we present and demonstrate a software-defined super-channel transmission based on time frequency packing and on the proposed differentiated filter configuration (DFC). Time frequency packing is a technique able to achieve high spectral efficiency even with low-order modulation formats (e.g., quadrature phase-shift keying). It consists in sending pulses that overlap in time or frequency or both to achieve high spectral efficiency. Coding and detection are properly designed to account for the introduced inter-symbol and inter-carrier interference. We present a software defined network (SDN) controller that sets transmission parameters (e.g., code rate) both at the transmitter and the receiver side. In particular, at the transmitter side, a programmable encoder adding redundancy to the data is controlled by SDN. At the receiver side, the digital signal processing is set by SDN based on the selected transmission parameters (e.g., code rate). Thus, extensions to the OpenFlow architectures are presented to control super-channel transmission based on time frequency packing. Then, the SDN-based DFC is proposed. According to DFC, the passband of the filters traversed by the same connection can be configured to different values. Experiments including data and control planes are shown to demonstrate the feasibility of optical-reach-adaptive super-channel at 1 Tb/s controlled by extended OpenFlow. Then, the effectiveness of the proposed SDN-based DFC is demonstrated in a testbed with both wavelength selective switches and spectrum selective switches, where filters traversed by a connection requires different passband values. Extended OpenFlow messages for time frequency packing and supporting DFC have been captured and shown in the paper.