This paper explores the potential of forced convection cooling in a ducted photovoltaic façade unit. Where a photovoltaic panel is backed by a 5 cm thick insulated duct at a depth of 50 cm. The potential of heat removal from the photovoltaic unit due to forced convection is investigated with a range of fan speeds from 1 m/s to 6 m/s. It is found that the ΔT between the inlet and outlet of the duct ranged from 2.6–24.6 °C. A fan speed of 4 m/s yielded the highest cooling potential by removing 550 W with a cooling efficiency of 51%. Whereas a fan speed of 6 m/s yielded the lowest mean PV cell temperature of 62.7 °C. This would improve the cell’s efficiency by 17.53%. This very experimental setup has been tested previously with natural convection cooling, which removed 529 W with a maximum efficiency of 48.98% This improves PV panel efficiency by 12.69%. The addition of heat removed and power recovered by the ducted system was 68.53% of the former (i.e., forced convection), while it was 61.67% for the latter. A 12 V DC fan with a variable speed electric circuit powered by a fraction of the PV generated power (i.e., 0.75 W) yielded better cooling that translated into nearly 19 W of further energy generation.
This paper presents an investigation into the effect of area ratio parameter of diffusers on its energy output through power coefficient Cp. This parameter has effect both on diffusers’ energy yield, besides diffuser’s size for architectural integration prospects. A systematic increase in diffusers area ratio is adopted following standardized diffuser profile presented by NACA 1244 aerofoil. A series of area ratios were investigated (i.e., 1.25, 1.5, 1.75, 2, 2.5, 3 and 3.5). Area ratio of 1.5 (i.e., outlet/inlet, 0.75 m/0.50 m) exhibited the highest power coefficient Cp of 4.2, in addition to achieving highest resulting velocity of 25.8 m/s under incident velocity of 16m/s. Considerable wind separation inside inner walls of diffusers occurred from area ratio 1.75 onwards, which impacted resulting velocities. Simulations performed with ANSYS CFD Academic to standalone diffusers. A series of incident velocities employed from 1 to 16 m/s that resulted in velocity increase by 120–156% respectively.
24 September 2025 in Architecture, Structures and Construction