Growing perovskite on textured silicon: Wide–band gap perovskites could boost the efficiency of silicon solar cells by forming tandem cells, but usually the perovskite must be grown on a smoothed side of the silicon cell because the material grown on the rough light-trapping side often does not fully coat the silicon surface and its rough texture is prone to phase separation. Hou et al. grew thick films of a perovskite with a band gap of ∼1.68 electron volts and used a passivant, 1-butanethiol, to limit its phase separation. The tandem cells had a certified power conversion efficiency of 25.7% and had negligible losses after 400 hours of operation. Science , this issue p. 1135
The need for optoelectronic and chemical compatibility between the layers in colloidal quantum dot (CQD) photovoltaic devices remains a bottleneck in further increasing performance. Conjugated polymers are promising candidates as new hole‐transport layer (HTL) materials in CQD solar cells (CQD‐SCs) owing to the highly tunable optoelectronic properties and compatible chemistries. A diketopyrrolopyrrole‐based polymer with benzothiadiazole derivatives (PD2FCT‐29DPP) as an HTL in these devices is reported. The energy level, molecular orientation, and hole mobility of this HTL are manipulated through molecular engineering. By levering the polymer's optical absorption spectrum complementary to that of the CQD active layer, EQE across the visible and near‐infrared regions is maximized. As a result, a PD2FCT‐29DPP‐based device exhibits a fill factor of 70% and approximately 35% efficiency enhancement compared to a PTB7‐based device.