The quality of a building desponds directly on the quality of concrete, and mixing is the key process of concrete production. However, a mixing blade is severely worn and has a relatively short life during the mixing process because of severe friction between the concrete material and the double-horizontal shaft mixer stirring blades. This study uses the abrasion mechanism of a mixer and the abrasive wear formula as bases to analyze the theoretical maximum line wear rate \(\eta\) of an experimental prototype at five blade installation angles, and obtain the optimal installation interval and optimal installation angle. Results indicate that the wear rate of different blade installation angles changes significantly. The wear rate at 45° is the largest, and the corresponding theoretical life is only 125 days. By contrast, the wear rate at 35° is the smallest, and the corresponding theoretical life is 192 days. The change rule of the maximum line wear rate \(\eta\) of the blade is obtained through the wear line chart, and the performance curve and evaluation function are fitted using MATLAB. The three aspects of stirring quality, energy consumption, and wear loss are quantitatively analyzed. The best installation angle and interval are 31.8° and 30°–34°. This study can provide a reference for the design choice of the installation angle of the mixing blade of concrete mixers.
The structural design of vehicles plays an important role in improving vehicle safety and driving performance. In this study, the frame structure of a van-type electric truck was taken as a research object. Stress, strain, and modal analyses of this frame structure were performed using Abaqus, a finite element software, to verify the rationality and safety of the structural design. The frame structure was optimized by numerical analysis. The fourth beam was moved 524 mm forward between the installation points of the power battery pack and the rear lifting lug of the front leaf spring. Results showed that the optimized frame bending, the full-load braking condition, and the full-load torsional operating condition stresses decreased by 44.499%, 23.364%, and 31.303%, respectively. The bending stiffness of an optimized frame increased by 4.026%, whereas the front and rear torsional stiffnesses increased by 4.442% and 4.092%, respectively.