Black carbon (BC) emissions intensify global warming and are linked to adverse health effects. The International Maritime Organization (IMO) considers the impact of BC emissions from international shipping. A prerequisite for the anticipated limits to BC emissions from marine engines is a reliable measurement method. The three candidate methods (photoacoustic spectroscopy (PAS), laser-induced incandescence (LII), and filter smoke number (FSN)) selected by the IMO were evaluated with extensive ship exhaust matrices obtained by different fuels, engines, and emission control devices. A few instruments targeted for atmospheric measurements were included as well. The BC concentrations were close to each other with the smoke meters (AVL 415S and 415SE), PAS (AVL MSS), LII (Artium-300), MAAP 5012, aethalometers (Magee AE-33 and AE-42), and EC (TOA). In most cases, the standard deviation between instruments was in the range of 5–15% at BC concentrations below 30 mg Sm⁻³. Some differences in the BC concentrations measured with these instruments were potentially related to the ratio of light-absorbing compounds to sulphates or to particle sizes and morphologies. In addition, calibrations, sampling, and correction of thermophoretic loss of BC explained differences in the BC results. However, overall differences in the BC results obtained with three candidate methods selected by the IMO were low despite challenging exhaust compositions from marine diesel engines. Findings will inform decision making on BC emission control from marine engines.

Emissions of marine traffic can be lowered by switching to less polluting fuels or by investing in exhaust aftertreatment. Electrostatic precipitation is a widely used method for particle removal but it is not currently used in combination with marine engines. This study presents the particle filtration characteristics of an emission reduction system designed for marine applications and consisting of a scrubber and a Wet Electrostatic Precipitator (WESP) in series. Partial flow of exhaust from a 1.6 MW marine engine, operated with light and heavy fuel oil, was led to the system. Particle concentrations were measured before the system, after the scrubber and after the WESP. Particle removal characteristics were determined for different engine loads. The scrubber alone removed 15–55% of non-volatile particle number, 30–40% of particle mass and 30–40% of black carbon mass depending on engine load, when HFO fuel was used. By studying particle size distributions, scrubber was found also to generate particles seen as an additional mode in 20–40 nm size range. The system combining the scrubber and WESP removed over 98.5% of particles in number, mass and black carbon metrics when HFO fuel was used. With MDO fuel, 96.5% of PN and 99% of black carbon were removed.