Currently, Quality-of-Service (QoS)-aware routing is one of the crucial challenges in Software Defined Network (SDN). The QoS performances, e.g. latency, packet loss ratio and throughput, must be optimized to improve the performance of network. Traditional static routing algorithms based on Open Shortest Path First (OSPF) could not adapt to traffic fluctuation, which may cause severe network congestion and service degradation. Central intelligence of SDN controller and recent breakthroughs of Deep Reinforcement Learning (DRL) pose a promising solution to tackle this challenge. Thus, we propose an on-policy DRL mechanism, namely the PPO-based (Proximal Policy Optimization) QoS-aware Routing Optimization Mechanism (PQROM), to achieve a general and re-customizable routing optimization. PQROM can dynamically update the routing calculation by adjusting the reward function according to different optimization objectives, and it is independent of any specific network pattern. Additionally, as a black-box one-step optimization, PQROM is qualified for both continuous and discrete action space with high-dimensional input and output. The OMNeT ++ simulation experiment results show that PQROM not only has good convergence, but also has better stability compared with OSPF, less training time and simpler hyper-parameters adjustment than Deep Deterministic Policy Gradient (DDPG) and less hardware consumption than Asynchronous Advantage Actor-Critic (A3C).

With the advent of 6G technologies, satellite communication networks are in urgent need of innovative bearer technologies to meet the demands of government and enterprise private lines as well as computing power networks. We propose optical service unit-based optical inter-satellite links (OISL-OSU) as a solution to address the current limitations in fine-grained service bearing within optical transport networks (OTNs), thereby enhancing the flexibility and efficiency of satellite optical networks. Comparative tests were conducted between OISL-OSU and existing packet-switching technologies in multi-service satellite optical transport networks. Through hardware-in-the-loop simulation verification, key performance indicators such as delay optimization, bandwidth utilization rate, and flexible resource adjustment capability were systematically evaluated. Experimental results demonstrate that OISL-OSU technology exhibits superior performance in delay optimization and fine-grained service bearing. The flexible mapping and multiplexing mechanism of OISL-OSU significantly improves resource utilization efficiency, decreases transmission delay, and strengthens hard-pipe connection capabilities.

Power system visualization is a technology combining power science with multi-disciplinary science, which integrates with computer graphics, and geography, ergonomics and other disciplines. Power system visualization provides a vivid way for the engineer to study energy management system in a variety of means. This paper presented a framework of visualization platform in power system, around the supporting platform technology and hierarchical display technology of visualization. By comparison, we make decision on graphics development kit. Two-dimension and three-dimension visualization techniques are demonstrated in this paper. These visualization techniques enrich power system visualization. Hierarchical tree view and multi-theme window display technology are presented for more information. By using this framework of visualization, dispatcher can find problem in time and take appropriate measures. The visualization platform has been applied in the China's smart power grid construction and brings significant social and economic benefits. The visualization platform hugely enhanced dispatch level of power system, and is helpful to transfer traditional dispatching into intelligent dispatching.

Facing the growing high data rate and large communication capacity demands, optical communications are widely recognized to be used to implement satellite communications. For a space-based optical backbone network, an appropriately designed protocol stack is important. In this paper, we proposed a protocol stack that is suitable for a space-based optical backbone network. Following this, we then used software to simulate this stack, built a hardware platform to test it, and finally, analyzed the results. The results showed that the proposed protocol stack was well designed to provide efficient control and management of the space-based optical backbone network. It could improve management efficiency by collecting resources and automatically calculating and building route paths. It could also facilitate data forwarding in intermediate satellite nodes with limited source and power, by using an advanced orbiting systems (AOS) frame switching scheme to avoid unnecessary processes, such as unpacking, upper-layer processing and repacking for passing services. The protocol stack could also support the use of unidirectional links to improve the link resource utilization. Finally, it could also provide transparent transmission for different kinds of services.

With the explosion of traffic demand in recent years, the integration of satellite optical networks and terrestrial networks (ISTN) creates a promising networking solution for future low-latency, high-rate, and high-capacity communications. Owing to the high cost of deploying and maintaining a satellite optical network, it is critical to carefully design and plan the network to ensure the performance of the network. Thus, a semi-physical simulation platform based on software-defined networks (SDNs) is developed to simulate a satellite optical network and evaluate the performance of the proposed label-based advanced orbiting system (AOS) frame switching method that adheres to the Consultative Committee for Space Data Systems’ recommended standard (CCSDS). The semi-physical simulation platform has two major innovations: (1) adapting and integrating network protocols between the CCSDS and open system interconnect (OSI) reference models, particularly at the data link layer, and (2) the foundation for an SDN-based satellite optical network. In the control plane, real-time VxWorks Simulators serve as controllers to establish and manage various network protocols and the link manager protocol (LMP). Here, network protocols include open shortest path first (OSPF) for routing managing and controlling messages, constraint shortest path first–traffic engineering (CSPF-TE), and constraint-label distribution protocol (CR-LDP) for routing data services. LMP is used to assign and reserve satellite optical link resources. The performance of the architecture and protocols is evaluated via a semi-physical simulation platform.