A new series of wide band gap photovoltaic polymers based on a fluorinated phenylene-alkoxybenzothiadiazole unit with an optical band gap of over 1.90 eV are designed and utilized for high-performance single- and multi-junction bulk heterojunction polymer solar cells.
Solution processability is one of the advantages of organic solar cells (OSCs). However, most high-efficiency OSCs are prepared using hazardous chlorinated solvents for the deposition of photoactive layers. The replacement of non-halogenated solvents with eco-friendly green solvents for photoactive materials is urgently required. Herein, we have developed a novel asymmetric T2-OEHRH, which is modified from the symmetric T2-ORH. The introduction of asymmetric alkyl side chains onto rhodanine end groups can effectively suppress excessive self-aggregation/crystallization and substantially improve solubility without sacrificing optoelectrical properties. Therefore, ternary-blend OSCs based on PTB7-Th:EH-IDTBR:T2-OEHRH processed using a non-halogenated solvent system exhibit a uniform and favorable morphology and give a high power conversion efficiency (PCE) of 12.10%. More importantly, we demonstrate an impressive PCE of 9.32% for large-area NFA-OSCs (substrate size = 100 cm2 and aperture size = 55.5 cm2) prepared via D-bar coating in air. To our knowledge, this PCE is the highest reported to date for NFA-based large-area OSC modules processed from a non-halogenated solvent. This asymmetric alkyl-chain engineering strategy can be exploited to develop high-performance large-area NFA-OSCs with eco-friendly solvent processing.
Utilizing the N-annulated PDI acceptor PDI–DPP–PDI, a simple air-processed and air-tested organic photovoltaic device fabrication procedure has been established to streamline the screening of donor materials. Post-deposition solvent vapour annealing of the active layer blend results in a preferential re-organization dictated by PDI–DPP–PDI and is responsible for significant increases in device performance. Employing this method, a series of low-cost and scalable donor polymers were screened to help select promising candidates as alternatives to the expensive high-performance donor polymer PTB7-Th. Universal improvements in performance upon solvent vapour annealing with a range of donor polymers highlighted the advantages of PDI–DPP–PDI and this post-deposition treatment. This facile screening protocol identified PDTT-BOBT as the most suitable PTB7-Th alternative in the surveyed series, with the best device efficiencies reaching 4.5% PCE compared to control devices with PTB7-Th at 4.6% PCE.