Promising ZnMn2O4 anode provides high capacity in Li-ion batteries and the capacity increase during cycling due to the reversible Li storage in SEI and the extra redox reaction of Mn(ii)/Mn(iii).
The Li + storage mechanism in a carbon composited zinc sulfide as an enhanced conversion-alloying anode material for Li + ion batteries is studied by in situ methods. Further, it is found that the (de)lithiation processes are affected by a low charge transfer resistance, and the coated carbon can effectively improve the long-term cycling stability.
In this study, sodium titanium phosphate/reduced porous graphene oxide (NTP/rPGO) composites are used as novel electrode materials for hybrid capacitive deionization (HCDI). The composites are synthesized through assembling the NaTi2(PO4)3 precursor with etched graphene oxide under hydrothermal condition. The NTP/rPGO composites demonstrate a porous hierarchical structure, where uniformly dispersed NaTi2(PO4)3 particles are attached on the rPGO sheets, which provide abundant adsorption sites, highly conductive networks, and short diffusion lengths for salt ions. Benefiting from the redox reaction of the NTP and electrical double-layer capacity of the rPGO, the NTP/rPGO composite containing 77 wt % NaTi2(PO4)3 presents a high specific capacity of 396.42 F g–1 and a high electrosorption capacity of 33.25 mg g–1 at the voltage of 1.4 V with the initial salt conductivity of 1600 μS cm–1 (786 mg L–1). Further, it also shows excellent recycling stability and rapid desalination rate of 0.30 mg g–1 s–1 (100 times as fast as the bare graphene electrode). Therefore, the NTP/rPGO composites exhibit a promising prospect for desalination application in the HCDI system.
Replacing liquid electrolytes with solid ones can provide advantages in safety, and all‐solid‐state batteries with solid electrolytes are proposed to solve the issue of the formation of lithium dendrites. In this study, a crosslinked polymer composite solid electrolyte was presented, which enabled the construction of lithium batteries with outstanding electrochemical behavior over long‐term cycling. The crosslinked polymeric host was synthesized through polymerization of the terminal amines of O,O‐bis(2‐aminopropyl) polypropylene glycol‐block‐polyethylene glycol‐block‐polypropylene glycol and terminal epoxy groups of bisphenol A diglycidyl ether at 90 °C and provided an amorphous matrix for Li+ dissolution. This composite solid electrolyte containing Li+ salt and garnet filler exhibited high flexibility, which supported the formation of favorable interfaces with the active materials, and possessed enough mechanical strength to suppress the penetration of lithium dendrites. Ionic conductivities higher than 5.0×10−4 S cm−1 above 45 °C were obtained as well as a wide electrochemical stability window (>4.51 V vs. Li/Li+) and a high Li+ diffusion coefficient (≈16.6×10−13 m2 s−1). High cycling stability (>500 cycles or 1000 h) was demonstrated.