Defect state may be created on the grafitic bonding of carbon atoms as the dangling bonds of the reduced graphene oxide (rGO) compound. In this study, the rGO sample has been prepared by burning the coconut shell in air. The resulted burnt samples were then heated at varying temperatures (400, 700, and 1000 o C) for 5 hours in air. Further, a mechanical exfoliation process using ultrasonic vibrator was added to the samples for 5 hours. Characterization using Raman spectroscopy exhibited that the intensity ratio of defect (ID) and graphene (IG) increases, implying the increase of defect number, with respect to the increasing heating temperature. According to the magnetic property measurement using vibrating sample magnetometer (VSM), it is shown that the magnetization enhances with incerasing number of defects, featuring an occurrence of defect-induced magnetism in rGO.
15 November 2016 in Journal of the Physical Society of Japan
To investigate the electronic state of Ce-free and Ce-underdoped high-Tc cuprates with the so-called T′ structure, we have performed muon spin relaxation (μSR) and specific heat measurements of Ce-free T′-La1.8Eu0.2CuO4+δ (T′-LECO) polycrystals and Ce-underdoped T′-Pr1.3−xLa0.7CexCuO4+δ (T′-PLCCO) single crystals with x = 0.10. The μSR spectra of the reduced superconducting samples of both T′-LECO with Tc = 15 K and T′-PLCCO with x = 0.10 and Tc = 27 K have revealed that a short-range magnetic order coexists with the superconductivity in the ground state. The formation of a short-range magnetic order due to a very small amount of excess oxygen in the reduced superconducting samples strongly suggests that the Ce-free and Ce-underdoped T′-cuprates are strongly correlated electron systems.
In this study, the effect of heating temperature on the structure of graphenic-based carbon (GC) has been successfully investigated. A series of GC materials was prepared from coconut shells by a green synthesis method. The process includes heating at four temperatures (T = 400, 600, 800 and 1000 °C) followed by an exfoliation process assisted by hydrochloric acid (HCl). These materials were characterized by wide- and small-angle x-ray scattering (WAXS and SAXS), Fourier-transform infrared spectroscopy (FTIR), x-ray photoemission spectroscopy (XPS) and transmission electron microscopy (TEM). The WAXS analysis shows Braggs peaks corresponding to the reduced graphene oxide (rGO)-like phase. Investigations by FTIR and XPS methods show the presence of carbon-oxygen functional groups such as C=C (carbon with sp2 hybridization), C–C (carbon with sp3 hybridization), and C=O bonds. The sp2 bonds form a 2-dimensional (2D) network in hexagonal lattice, while carbon with sp3 bonds tends to form a 3-dimensional (3D) tetrahedral structure. The BET analysis revealed meso- and micro-pore structures in GC. Heating process reduces the specific surface area and increases pore size of GC. Moreover, increasing the heating temperature induces a decrease in radius of gyration (Rg) and an increase in the formation of 2D structures in GC. The fitting results of SAXS profiles, proved by TEM and XPS, yielded the structure of GC containing the mixture of 2D and 3D structures. Thus, it is suggested that the GC has a mesostructure.
26 August 2023 in Journal of Sol-Gel Science and Technology
Reduced graphene oxide (r-GO)powder has been prepared from coconut shells by carbonization process at 400°C for 3, 4 and 5 hours.Theresulted sample mass was reduced to be 60% relativelycompared to the starting material. The longer heating duration has also led to the rGO with reduced crystalinity according to the X-ray diffractometry data and TEM. The rGO solution was prepared by adding powders of 5, 10 and 15 grams into 50 ml destiled water and then centrifused at 6000 rpm for 30 minutes.The resulted solutions were seen to be varied form clear transparant, light and dark yellow to black. Measurement using particle size analyser shows that the individual rGO particles tends to be agglomerating each others to form bigger size clustering, manifested by the observed bigger size particles for the increasing amount of soluted rGO powders in water.The varying UV-visible spectra of these rGO solutions together with their optical bandgaps will also be discussed in this study.