We report an investigation on the photo-response from a GeSn-based photodetector using a tunable laser with a range of incident light power. An exponential increase in photocurrent and an exponential decay of responsivity with increase in incident optical power intensity were observed at higher optical power range. Time-resolved measurement provided evidence that indicated monomolecular and bimolecular recombination mechanisms for the photo-generated carriers for different incident optical power intensities. This investigation establishes the appropriate range of optical power intensity for GeSn-based photodetector operation.
We report the electroluminescence of a planar p-i-n diode based on an undoped GeSn layer where the p- and n-type electrodes are fabricated by using the CMOS process of ion implantation. The measurement shows a broad spectrum at a peak energy located below the bulk bandgap of Ge associated with indirect optical transition analyzed by taking into account composition- and strain-dependent modeling. This work provides an alternative approach to the fabrication of GeSn-based p-i-n light-emitting diodes as well as moving towards the integration with waveguided on-chip group IV photonic devices.
Ni/95Pb-5Sn/Cu ternary diffusion couples were used to investigate the cross-interaction between Ni and Cu across a layer of 95Pb-5Sn solder. High-lead solder layers with a thickness of 100 μm or 400 μm were electroplated over Cu foils. A pure Ni layer (20 μm) was then deposited over the as-deposited high-lead solder surface. The diffusion couples were then aged at 150°C to 250°C for different periods of time. With this technique, the diffusion couples were assembled without experiencing any high-temperature process such as reflow, which would have accelerated the interaction and caused difficulties in analysis. This study revealed that massive spalling also occurred during aging even though reflow was not used. The massive spalling began with the formation of microvoids. When the microvoids had congregated into large enough voids, intermetallic compounds (Cu3Sn) started to spall from the interface. This spalling phenomenon occurred sooner with increasing temperature and decreasing solder volume.
We report an investigation of the Schottky barrier height (SBH) of Ni/n-type Ge and Ni/n-type GeSn films that is annealed at a wide range of temperatures. Both voltage- and temperature-dependent current–voltage (I–V) measurements are performed. From the analysis of these nonlinear I–V traces, the SBH is found and the results shows that the SBH of Ni/n-type GeSn (a) is smaller than that of Ni/n-type Ge and (b) decreases with the Sn content of the surface GeSn layer associated with the thermal annealing. By modeling the composition- and strain-dependent energy bandgap (Eg), the relationship between the SBH and Eg is established and it is found that SBH/Eg ∼0.8. These results suggest that the GeSn film could serve as an interfacial layer for the reduction of the SBH in Ge-based electronic devices that are desirable for applications.