This review examines a variety of adsorbents and discusses mechanisms, modification methods, recovery and regeneration, and commercial applications. A summary of available researches has been composed by a wide range of potentially low-cost modified adsorbents including activated carbon, natural source adsorbents (clay, bentonite, zeolite, etc.), biosorbents (black gram husk, sugar-beet pectin gels, citrus peels, banana and orange peels, carrot residues, cassava waste, algae, algal, marine green macroalgae, etc.), and byproduct adsorbents (sawdust, lignin, rice husk, rice husk ash, coal fly ash, etc.). From the literature survey, different adsorbents were compared in terms of Zn²⁺adsorption capacity; also Zn²⁺adsorption capacity was compared with other metals adsorption. Thus, some of the highest adsorption capacities reported for Zn²⁺are 168 mg/g powdered waste sludge, 128.8 mg/g dried marine green macroalgae, 73.2 mg/g lignin, 55.82 mg/g cassava waste, and 52.91 mg/g bentonite. Furthermore, modification of adsorbents can improve adsorption capacity. Regeneration cost is important, but if consumption of virgin adsorbent is reduced, then multiple economic, industrial, and environmental benefits can be gained. Finally, the main drawback of the already published Zn²⁺adsorption researches is that their use is still in the laboratory stage mostly without scale-up, pilot studies, or commercialization.

The sorption mechanisms, point of zero charge, and isosteric heats involved in the adsorptive dephenolization of aqueous solutions using thermally modified corn cob (TMCC) were studied at different initial phenol concentrations (100–500 mg/l), TMCC dosage (0.4–2.0 g), contact time (5–60 min), pH (2–10), and temperature (30–60°C). Analysis of the adsorbent material showed that it possessed the properties typical of a good adsorbent. The adsorption experiments revealed that phenol uptake is favored by an increase in TMCC dosage and contact time and a decrease in temperature and concentration of phenol in the solution. The experimental data were well-fitted to the Sips, Langmuir, Toth, and Redlich–Peterson isotherm models. Thermodynamic studies suggested that the sorption of phenol onto TMCC is feasible, spontaneous, and endothermic. The isosteric heats of adsorption obtained are in the range 47.43-79.38 kJ/mol, confirming that the adsorption process is predominantly a physical process depicting the van der Waals interactions, and it is inversely proportional to surface loading. The analysis of the adsorption mechanisms showed that the intraparticle, film, and pore diffusion mechanisms were significantly involved in the phenol adsorption process. The involvement of electrostatic attraction, electron-donor interaction, and hydrogen bonding was also demonstrated. The point of zero charge () was obtained at a pH of 5.83; being slightly lower than the optimum pH of 6 indicates that the sorbent surface is obviously not negatively charged at . The discoveries of this study have shown that the dephenolization process is feasible, spontaneous, endothermic, dominated by a physical process, and governed by intraparticle, film, and pore diffusion mechanisms.