A pipe water hammer with column separation was studied in a range of flow rates ( to 2239) in a test rig with an acrylic glass observation section. Pressure transients were measured with piezoresistive pressure sensors, while the gas evaporation and condensation were captured by high-speed recording with a Photron SA-Z at a frame rate of 75,000 fps. Separation lengths were estimated by a threshold value in the images. The results did not show a sharp gas–oil interface but consisted of small, dispersed bubbles mixed with larger vapor structures, where the bubbles seemed to become smaller after each collapse. These findings differ from the transient cavitating characteristics commonly reported in nonhydraulic piping systems governed by different fluid properties and time scales. Good repeatability, both in terms of pressure transients and bubble distribution, was observed. The column separation was quantified as a metric of separation length, which was consistent between the tests. Combined with pressure measurements, these results may assist in obtaining a better understanding of the transient cavitation dynamics within oil–hydraulic systems as well as be used to improve modelling strategies towards more accurate cavitation erosion predictions.
Cavitation erosion through water hammer and column separation is a major concern in hydraulic applications such as percussive rock drilling. Cavitation aspects must be considered both in early and late design stages, which require deep knowledge and tools for prediction. In this study, an oil-hydraulic test equipment for water hammer assessment was designed using state-of-the-art simulation tools. Several tests were performed, with and without column separation, showing good repeatability on measured pressures. At higher flow rates, column separation was the dominating feature and several high-pressure peaks with subsequent time delay reduction could be observed. These patterns were affected by the oil temperature, with most substantial changes at lower temperature ranges (<32 °C). Standard transmission line simulations managed to predict the water hammer, but as expected not the column separation, which is the theme of future work using this setup.