Vehicle electrification places significant pressures on electric machine design due to the need for increased power densities and mass production. These two requirements couple when designing multistrand stator windings, which exhibit significant AC loss variability as a result of the random nature of the conductor lay within the stator slot caused by automated insert winding. This paper presents two prediction methods for AC loss variability to be deployed at the winding design stage. The first consists of an analytical approach, whilst the second constructs a 2D finite element analysis geometry that captures conductor lay characteristics. Comparison of predictions from both approaches to experimental AC loss measurements established that the proposed models capture the experimentally observed AC loss variability characteristics and that the analytical method is suitable for early design stages whilst the finite element approach should be adopted once the winding configuration is finalised.
Aircraft landing gear structures are exposed to complex loading in-service. Coupled with the geometry and joints used within landing gear structural assemblies, finite element models tend to be used to compute the loads acting on landing gear components during ground maneuvers. Concerning novel design approaches for complex structural assemblies, such as probabilistic assessment, optimization or ‘digital-twins’, the computational expense of using finite element models is prohibitive. Surrogate modeling methods have been proposed as a route to reducing the computational expense of assessing complex structural assemblies for static and fatigue design. This paper investigates the application of Response Surfaces, Radial Basis Functions, Gaussian Process Regression and Artificial Neural Networks as approaches to surrogate modeling for landing gear load models. Following the construction of the surrogate models within case studies representing a side stay and complex drag brace component, it was identified that Response Surface and Gaussian Process Regression surrogate models could be used to reduce the computational expense of a landing gear loads assessment from 20 seconds to less than a millisecond. As a result, surrogate modeling methods provide the required reduction in computational expense to support probabilistic design and optimization of complex structural assemblies.
Landing gear are exposed to cyclic loads from the ground manoeuvres that aircraft perform in-service. Variability is observed in the loading magnitude associated with ground manoeuvres, along with the per-flight variability in ground manoeuvre occurrence and sequencing. Whilst loading magnitude variability has been widely characterised, significant assumptions are required regarding manoeuvre occurrence and sequencing when constructing landing gear load spectra for fatigue design. These assumptions are required due to the limited availability of data concerning ground manoeuvre occurrence and sequencing relating to aircraft in-service and require validation to facilitate the design of more efficient components. ‘Big-Data’ approaches, employing Automatic Dependent Surveillance-Broadcast (ADS-B) transponder data, enable aircraft ground tracks to be identified. This paper presents a methodology to characterise the variability in ground manoeuvre occurrence and sequencing using ADS-B data sourced from Flightradar24® for a wide-body aircraft fleet. Using statistics generated for the fleet, it was identified that significant variability exists in the occurrence and sequencing of turning and braking manoeuvres. The statistics also validate existing assumptions, including that the proportional share of left and right turning manoeuvres is equal. Finally, this paper discusses the utility of ADS-B datasets for constructing landing gear load spectra and monitoring of landing gear in-service.
Significant challenges exist when defining the usage spectra of helicopter components due to the wide range of missions and manoeuvres flown by helicopters in-service. Automatic Dependent Surveillance-Broadcast (ADS-B) trajectories provide a means of constructing helicopter flight manoeuvre statistics across entire in-service fleets. This paper explores the feasibility of characterising helicopter manoeuvres by applying rule-based algorithms to ADS-B trajectories from a fleet of twin-seat training helicopters. Despite challenges relating to low-altitude ADS-B coverage, a comprehensive set of flight manoeuvre statistics was generated, which highlighted that significant variability exists in helicopter flight manoeuvre occurrences. The generated statistics can also support validation activities concerning design usage spectra assumptions.