Natural gas is the primary source of energy, accounting for around 20% of the world’s energy production. It is also a key element in reducing CO2 emissions due to its key role in stabilizing renewable energy sources. At the same time, natural gas as a fossil fuel that emits CO2 should be limited. A natural candidate that can ensure the stabilization of RES and at the same time reduce the demand for fossil fuels is biogas. Successful use of biogas requires a thorough understanding of the potential, structure, and specifics of its sources and production technology. The presented study provides a perspective and a brief overview of the existing potential of biogas production. Poland was chosen as the case study and it was shown that almost 90% of the Polish biogas potential comes from sources with a capacity below 100 Nm3/h, which is the current minimum commercially available capacity of the biogas purification and liquefaction technologies. Consequently, full utilization of these sources would require a downsizing of these technologies.
Atmospheric microwave plasma was applied to the processing of the partially cleaned producer gas obtained from sewage sludge gasification. The plasma processing resulted in residual tar compounds conversion and changes in the gas composition. During the tests with a different gas flow rates and microwave power inputs, liquid and gaseous samples were collected to evaluate the plasma reactor’s performance. The conversion efficiency ranged from 19 to 100% and it depended on the specific energy input (SEI), gas flow rate, initial tar concentration, and the nature of the tars compounds. Generally, it was shown that the conversion rate increased with the SEI and that the aliphatic, cyclic and substituted compounds were converted much easier than benzene. Moreover, applying plasma led to the production of heavier aromatics (i.e. naphthalene, indene, acenaphthylene) but the rise in their concentration was significantly smaller than the amount of converted compounds. The gas composition changes revealed in the increase of H2 and CO concentration that was an effect of hydrocarbons and CO2 conversion. Additionally, it was indicated that the microwave plasma reactor’s performance was noticeably worse than in the case of the laboratory test with a simulated producer gas. This was mainly attributed to differences in the reactors’ geometry, lower hydrogen concentration and the presence of inorganic deposit on the reactor’s walls that might have inhibited microwaves transfer. In general, the microwave plasma technology seems promising in the context of cleaning and upgrading the producer gas, however, further optimization research is necessary to make it more reliable and less energy consuming. Graphic Abstract
2 June 2020 in Journal of the Air & Waste Management Association
This article presents the results of an industrial-scale study (on 400 MWe lignite fired unit) of simultaneous NOx, SO2, and HgT removal in FGD absorber with oxidant injection (NaClO2) into flue ga...