Universidade Federal de São Paulo, Dept Ophthalmol, São Paulo, BrazilUniversidade Federal de São Paulo, Dept Ophthalmol, São Paulo, BrazilWeb of Scienc
Background: Dual pneumatic systems use two separate air line tubes to open and close the cutter and can achieve high cut rates. The purpose of this study is to evaluate the influence of gauge size, cut rate and aspiration on the flow rate performance of ultra high-speed cutters operated with a commercially available dual pneumatic vitrectomy system. Methods: Analysis of a high-speed video was used to determine duty cycle. Flow rates from 20-, 23- and 25-gauge cutters were calculated in predetermined conditions of aspiration levels and cut rates; water and fresh porcine vitreous samples were studied. Results: For all three gauges of cutters, the duty cycle and water flow showed an inverse correlation with increasing cut rates and a direct correlation with increasing aspiration levels (p < 0.05). Vitreous flow rates from all gauges increased with increasing aspiration and cut rates (p < 0.05). Conclusion: Larger gauges of the cutters as well as higher aspiration and cut rate levels resulted in improvement of the vitreous flow rates. A good understanding of the different flow rate settings is essential for the surgeon and optimizes the safety of surgical procedures.
To evaluate flow rates and duty cycle for different sizes of ultra-high-speed pneumatic vitreous cutters. A precision balance measured the mass of water and vitreous removed from a vial. Porcine vitreous was obtained within 12 hours of killed at a local slaughterhouse and kept at 4 °C. Twenty-, 23- and 25-gauge (n = 3 of each gauge) pneumatic cutters were tested at 0 (water), 1,000, 2,000, 3,000, 4,000, and 5,000 cuts per minute with aspiration levels of 100, 200, 300, 400, 500, and 600 mmHg. Frame-by-frame analysis of high-speed video was used to determine the duty cycle. Larger gauge cutters associated with higher aspiration levels produced greater vitreous and water flow rates (P < 0.05). As the cut rate increased, the vitreous flow rate increased (maximum flow at 5,000 cuts per minute) and the water flow rate decreased (P < 0.05). The duty cycle of the new-generation cutters decreased as cut speeds increased, using all 3 gauges (P < 0.001). Vitreous flow rates averaged 10 times less than water flow rates using the same cutter at the same settings. Ultra-high-speed vitreous cutters produce consistent vitreous and water flow rates across the tested range of cuts per minute and aspiration levels.
Aim To report a novel method to quantify traction applied to the retina using vitreous cutters during pars plana vitrectomy. Methods Fresh porcine eyes were positioned in a specially developed holder and transfixed to the retinal layers with a wire and the other end fixed to the load cell of a strain gauge. Five separate 20-gauge electrical drive mechanism vitrectors were introduced into the eye at a 45° angle and positioned at a distance of either 3 or 5 mm from the retina. Data from the strain gauge were acquired and the traction force computed. Results The analysis revealed that the vitreoretinal traction increased by 7.90 dynes for each 100 mm Hg increase in vacuum (p<0.05). The traction forces decreased by 2.51 dynes for each 500 cuts per minute increased (p<0.05) and the traction force increased by 2.17 dynes at 3 mm compared with 5 mm (p<0.05). Conclusion The traction was directly proportional to the aspiration vacuum and inversely proportional to the cut rate. The cutter traction force increased with proximity to the retina.
Purpose: To investigate the influence of the Factor H (CFH) Tyr(402)His polymorphism on the plasma levels of the alternative pathway proteins CFH, C3, Factor B (FB), Factor D (FD), and Factor I (FI) and the inflammatory marker C-reactive protein (CRP) in 119 patients with age-related macular degeneration (AMD) and 152 unrelated control individuals. Methods: Patients with AMD and the control group were separated according to CFH polymorphism, age, and gender. Plasma complement proteins and CRP concentrations were determined with enzyme-linked immunosorbent assay, immunodiffusion, or nephelometry. Results: Significant differences in the concentrations of FD and FI were observed between the patients with AMD and the control individuals. We observed significantly reduced FD plasma levels in patients with AMD. We also identified a significant decrease in CFH plasma levels in female patients with AMD in relation to female controls. Plasma FI levels were significantly increased in patients with AMD compared to the control group. Regarding gender, a significant increase in FI plasma levels was observed in male patients. Finally, we found no significant correlation between the CFH Tyr(402)His polymorphism and the CFH, C3, FB, FD, FI, and CRP plasma levels. Conclusions: Patients with AMD present altered levels of FD and FI in a manner independent of this CFH polymorphism, and gender apparently contributes to the plasma levels of these two proteins in patients with AMD and control individuals.