Ryuichi Sugie

Dr. Ryuichi Sugie

Toray Research Center Inc.
orcid

Research Focus & Metrics

Academic Career Length

32Years (1995-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 November 2017 in Journal of Applied Physics
Verified
Journal Article
Closed access
RSRyuichi Sugie
Ryuichi Sugie
TUTomoyuki Uchida
Tomoyuki Uchida
The stress dependencies of the phonon modes in a 4H silicon carbide (SiC) crystal were investigated. The deformation potentials of the A1(TO), E2, and E1(TO) modes were determined on the basis of uniaxial stress tests. The A1(TO) mode was sensitive to stress along the c axis, whereas the E1(TO) and E2 modes exhibited larger dependencies on the stress perpendicular to the c axis than the A1(TO) mode as expected from their atomic displacements. The coefficient of the frequency shift in the E2 mode for an isotropic biaxial stress in the c plane was determined to be −323 MPa/cm−1. We applied cross-sectional Raman measurements to SiC metal-oxide-semiconductor field-effect transistors. The horizontal and vertical stress components, σ11 and σ33, were derived from the frequency shifts of the E2 and A1(TO) modes using the deformation-potential constants. A compressive horizontal stress was observed near the interface between the SiC chip and the metals. The observed compressive stress increased as the temperature decreased. The main cause for the compressive horizontal stress at low temperature is considered to be the difference in the coefficients of thermal expansion of the SiC chip and the metals. The results suggest that the temperature of the fabrication process is one of the key factors for achieving a reduction in the thermal stress in the SiC power devices.

23 April 2014 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
YMYoriko Mizushima
Yoriko Mizushima
YKYoungsuk Kim
Youngsuk Kim
TNTomoji Nakamura
Tomoji Nakamura
RSRyuichi Sugie
Ryuichi Sugie
HHHideki Hashimoto
Hideki Hashimoto
TOTakayuki Ohba
Takayuki Ohba

17 December 2013 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
RSRyuichi Sugie
Ryuichi Sugie
KKKenichi Kosaka
Kenichi Kosaka
HSHirofumi Seki
Hirofumi Seki
HHHideki Hashimoto
Hideki Hashimoto
MYMasanobu Yoshikawa
Masanobu Yoshikawa
An experimental method to determine the temperature dependence of residual stress in three-dimensional (3D) structures was developed using polarized Raman spectroscopy. Stresses of a copper-filled silicon via at three temperatures, 223, 298, and 413 K were derived by measuring the frequency shift of the optical phonons through the backscattering geometry from the cross-section of the structure and assuming non-isotropic biaxial (horizontal and depth) stresses on the cross-section. Both stress components changed from tensile to compressive in almost all areas as the temperature changed from 213 to 413 K. The absolute stress values increased at both low and high temperatures and were smallest at 298 K, which was nearest to the process temperature of copper filling by plating. The main cause of stress is considered to be the difference in the coefficient of thermal expansion between copper and silicon. These results indicate that the temperature dependence of stress of copper-filled vias is affected mainly by their fabrication temperature. Process temperature is one of the key factors for the reduction of thermal stress in 3D structures such as integrated circuits connected by through-silicon vias.

26 February 2016 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
RSRyuichi Sugie
Ryuichi Sugie
TUTomoyuki Uchida
Tomoyuki Uchida
KKKenichi Kosaka
Kenichi Kosaka
KMKoji Matsumura
Koji Matsumura
Cross-sectional cathodoluminescence (CL) and scanning capacitance microscopy (SCM) measurements were carried out for silicon carbide (SiC) metal–oxide–semiconductor field-effect transistors (MOSFETs) to investigate process-induced defects. The DI defect-related line at 426 nm and a broad luminescence at approximately around 430–470 nm, which were produced by ion implantation, were observed in addition to the near-band-edge emission. CL images showed that the densities of nonradiative recombination and DI centers were high near the source region. Moreover, DI centers existed even in the n-drift region located 10 µm from the surface. These results indicate that many types of defects diffuse and interact with each other during annealing even in the area where dopant atoms are not implanted. The annealing process not only activates dopant atoms but also induces the diffusion of unstable native defects and transforms their structure into more thermally stable defects such as DI centers.

1 July 2012 in Microscopy and Microanalysis
Verified
Journal Article
Closed access
PDF file
SOS. Ogawa
S. Ogawa
TIT. Iijima
T. Iijima
SAS. Awata
S. Awata
RSRyuichi Sugie
Ryuichi Sugie
NKN. Kawasaki
N. Kawasaki
YOY. Otsuka
Y. Otsuka
Extended abstract of a paper presented at Microscopy and Microanalysis 2012 in Phoenix, Arizona, USA, July 29 – August 2, 2012.

3 December 2019 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
YNYosuke Nagasawa
Yosuke Nagasawa
RSRyuichi Sugie
Ryuichi Sugie
KKKazunobu Kojima
Kazunobu Kojima
AHAkira Hirano
Akira Hirano
MIMasamichi Ippommatsu
Masamichi Ippommatsu
SCShigefusa F. Chichibu
Shigefusa F. Chichibu
AlGaN-based deep-ultraviolet light-emitting diodes (LEDs) incorporating uneven multiple quantum wells (MQWs) with inclined and terrace zones, which were fabricated on an AlN template with dense macrosteps, have exhibited a high internal quantum efficiency (IQE). To investigate the microscopic structure of uneven MQWs, cathodoluminescence (CL) mapping characterization was carried out, and the maps of the CL intensity at 300 K relative to that at 38 K were obtained for uneven MQWs that targeted 265 and 285 nm LEDs. At an electron beam current of less than 1.0 nA, the signals from inclined and terrace zones of the uneven MQWs were confirmed to satisfy the nonsaturated excitation condition at 300 K. Nonradiative recombination (NR) was insufficiently frozen even at 38 K, specifically on the terraces in the 265 nm MQW, suggesting high concentrations of NR centers due to point defects (PDs). In contrast, NR in the 285 nm MQW at 38 K was closer to freeze-out. The concentration of PDs in the 285 nm MQW was likely to be lower than that in the 265 nm MQW. Finally, the ratios of the CL intensity at 300 K to those at 38 K were mapped, demonstrating an approach to creating an approximate map of IQE. The values in the CL intensity ratio maps are discussed by considering the analytical error factors. The results support the model of localized current injection through Ga-rich stripe zones in the n-AlGaN cladding layer.