Fracture network fracturing combined with oil–water infiltration and replacement is an effective approach to develop tight sandstone reservoirs. How to further improve oil recovery based on imbibition is a problem encountered during production. In this study, the core of the CHANG-7 tight sandstone reservoir in the Changqing oilfield of the China National Petroleum Corporation (CNPC) is studied. Combined with the newly designed core self-imbibition experiment, the mechanisms of salinity action are studied, and the influence of salinity on the process of imbibition oil recovery is quantitatively characterized. Research results show that the influence of salinity on the imbibition process of tight sandstone reservoirs takes place mainly through two ways; one is to reduce the oil–water interfacial tension, and the other is to construct an osmotic pressure displacement model. The salinity has significant influences on interfacial tension. The interfacial tension of low-salinity brine is only 1/5 of that of distilled water, but in the presence of high-efficiency surfactants, the influence of the salinity on the interfacial tension can be ignored; the greater the difference in salt concentration, the higher the core permeability and the greater the influence of salinity on the process of imbibition and oil recovery in tight sandstone reservoirs. At the initial stage of imbibition, the effect of salinity is less important than that of capillary force. On the contrary, the effect of salinity is much more important than that of capillary force in the middle of imbibition, and the imbibition curve shows a downward trend. At the later stage of imbibition, the fluid tends toward imbibition equilibrium, and the effects of capillary force and salinity are not obvious.

The well spacing for the development of tight reservoirs by multi-stage fracturing is continuously narrowed. Consequently, interwell interference during fracturing is more and more serious, accompanied by a host of issues in fracturing design and oil and gas production. However, the mechanism of interwell interference during fracturing is not explicit. The corresponding laws of the connectivity of rough fractures during fracturing, which plays a critical role in interwell interference, are not fully understood. In this study, on the basis of characterizing the roughness of fractures, a laboratory evaluation method for fracture connectivity was established. The connectivity characteristics of rough fractures and factors affecting the fracture connectivity are studied. The time and scale effects of fracture connectivity were discussed and their application in interwell interference was analyzed. The results show that the connectivity performance of rough fractures can be characterized by the time for pressure decay. The upstream pressure gradually decreases over time, and the decline rate is related to the fracture aperture, the fracture surface roughness, the contact area of the closed fractures, and liquid properties. Specifically, the decrease in fracture aperture and the increase in fluid viscosity leads to a significant reduction in fracture connectivity. While larger fracture surface roughness and contact area can make fracture connectivity better. The connectivity of the fracture system is one of the significant mechanisms causing interwell interference during fracturing. The connectivity of rough fractures formed during fracturing has remarkable scale and time effects. This study can effectively guide the fracturing design and the evaluation of the impact of fracture connectivity on production.

As an important replacement resource for conventional oil and gas, tight oil and gas are quite abundant. Long horizontal wells and multi-stage fracturing have become key technologies for developing tight oil and gas, and reasonable shut-in measures can improve the utilization efficiency of fracturing fluid. Therefore, it is especially critical to master the pressure transfer law during the shut-in process in tight reservoirs to further improve the energy efficiency of fracturing fluid. However, many studies have mostly focused on the separate design of fracturing, shut-in and production, and have not yet revealed the pressure transfer law during shutting in well based on the integration of fracturing, shut-in and production, which makes it difficult to realize the efficient development of tight oil and gas. Taking the tight oil reservoir in Block M as an example, the geological model of the target block was established using an integrated fracturing development software platform, on which the simulation of fracture extension, well shut-in and production was carried out. The changes in the reservoir pressure field during shutting in well were analyzed, and the influence law of fracturing fluid volume, shut-in time, reservoir original formation pressure and fracture network complexity on the effect of well shut-in were studied to optimize the shut-in system. It was found that the retained fluid increases, the pore pressure of the near-fracture matrix increases, and the diffusion distance of fracturing fluid to the distant matrix increases. The tight oil production increased after shutting in well, and the optimal retained fluid volume of 9600 m³ was actually preferred based on the model. The pore pressure of the near-fracture matrix decreases as the shut-in time increases, the diffusion distance of fracturing fluid to the distant matrix increases, and the pore pressure decreases with an increase in diffusion distance. The tight oil production increased after shutting in well, and the optimal shut-in time was actually preferred to be 90 days based on the model. The increase in formation pressure on abnormal low pressure formation is larger, and the production can be significantly improved after shutting in well. The more complex the fracture network is, the more obvious the non-uniform variation in matrix pore pressure during shutting in well. The research is of great significance for the optimal design of a shut-in system for tight reservoirs and the sustainable development of oil and gas resources in China.