Stability condition is of critical importance for methane hydrate exploitation, transportation, and reserves. This study measured the stability conditions of methane hydrate in fine-grained sediment with different dry densities ( = 1.40, 1.50 and 1.60 g/cm3) and various initial water saturations by the multi-step heating method. The experimental result showed that the methane hydrate formation in fine-grained sediment required lower temperature and/or higher pressure compared to that in bulk state. At the same time, it is found that the deviation degree of P–T conditions of methane hydrate in fine-grained sediment with different dry density and initial water saturation are completely different from that in pure water. In addition, according to the nuclear magnetic resonance technique (NMR), the changes in NMR signal intensity during the formation and decomposition of methane hydrate in silt were analyzed. Regardless of formation and dissociation stages, liquid water always distributes in the small sediment pores. An empirical formula is developed to address the capillary suction of water and hydrate with respect to the unhydrated water within sediment. Furthermore, a phase equilibrium model is proposed to predict the stability conditions of hydrate-bearing fine-grained sediment.
Rockburst is one of the most intense reactions in various instability phenomena of underground cavern surrounding rock, which seriously threatens the safety of underground engineering construction personnel and equipment. Based on Mohr–Coulomb strain softening model, the non-associated flow rule is adopted for plastic flow after material yield. By implanting Gu Ming-cheng and Tao Zhen-yu rockburst criterion in the software, the effects of different dilatancy angles on rockburst grade and circumferential stress distribution of surrounding rock of circular tunnel are simulated. The calculation results show that the larger the dilatancy angle is, the more difficult the rock burst pit is to form. The elements of serious rockburst are mainly concentrated in the wall of the tunnel, and the shear bands formed in the high value area of shear strain increment are short. When the dilatancy angle is small, the circumferential stress reaches the maximum at the interface of elastic-plastic zone. With the increase of dilatancy angle, the number of elements entering the plastic state and occurring medium and severe rockburst increases first and then decreases, while the number of elements occurring slight rockburst decreases monotonously. Different dilatancy angles have significant effects on the number of elements occurring rockburst at all levels.
1 December 2022 in Journal of Physics: Conference Series
Considering the influence of tensile plastic strain of intact rock on tensile strength and elastic modulus. The influence of arch curvature and height of the straight wall on the progressive failure of surrounding rock under different confining pressures are simulated based on the Mohr-Coulomb constitutive model and the nonlinear CWFS criterion of friction strengthening and cohesion weakening. The results show that when λ1 = 0.2, the difference between vertical load and horizontal load is large, the buckling failure of rock burst and slab cracking is obvious, and the sectional curvature effect is obvious. When λ3 = 0.5, the buckling failure of rock burst and slab cracking is very limited, the sectional curvature effect is reduced, and the confining pressure effect of rock burst and slab cracking is obvious. The shear yield localization of the surrounding rock is sensitive to sectional curvature, and the sectional curvature effect of shear failure under different lateral pressure coefficients is obvious. The numerical calculation results are consistent with the failure law of surrounding rock obtained from field and laboratory tests, which can provide a reference for tunnel excavation and support design.