In this paper, a new CMOS high-performance electronically tunable second-generation current conveyor (ECCII) is presented. The current gain of the proposed ECCII can be controlled electronically by adjusting the ratio of dc bias currents of the ECCII. The output terminal of the proposed ECCII has high impedance, which enables easy cascadability. Also, as an application, the proposed ECCII is used for realizing a universal current-mode filter. The filter realizes low-pass, bandpass, and high-pass responses simultaneously. The low-pass response is obtained at high impedance output and its gain can be independently tuned by changing the current gain of the relevant CC. SPICE simulation results using TSMC 0.35-/spl mu/m CMOS process model shows excellent performance for the proposed ECCII. The proposed circuit consumes average power of 6.6 mW using /spl plusmn/1.5-V supply voltages.

In this paper, using a minimum number of passive components, i.e., new grounded and floating inductance simulators, grounded capacitance multipliers, and frequency-dependent negative resistors (FDNRs) based on one/two modified current-feedback operational amplifiers (MCFOAs), are proposed. The type of the simulators depends on the passive element selection used in the structure of the circuit without requiring critical active and passive component-matching conditions and/or cancellation constraints. In order to show the flexibility of the proposed MCFOA, a single-input three-output (SITO) voltage-mode (VM) filter, two three-input single-output (TISO) VM filters, and an SITO current-mode (CM) filter employing a single MCFOA are reported. The layout of the proposed MCFOA is also given. A number of simulations using the SPICE program and some experimental tests are performed to exhibit the performance of the introduced structures.

In this paper, a new active element called voltage differencing inverting buffered amplifier (VDIBA) is presented. Using single VDIBA and a capacitor, a new resistorless voltage-mode (VM) first-order all-pass filter (APF) is proposed, which provides both inverting and non-inverting outputs at the same configuration simultaneously. The pole frequency of the filter can be electronically controlled by means of bias current of the internal transconductance. No component-matching conditions are required and it has low sensitivity. In addition, the parasitic and loading effects are also investigated. By connecting two newly introduced APFs in open loop a novel second-order APF is proposed. As another application, the proposed VM APF is connected in cascade to a lossy integrator in a closed loop to design a four-phase quadrature oscillator. The theoretical results are verified by SPICE simulations using TSMC 0.18 μm level-7 CMOS process parameters with ±0.9 V supply voltages. Moreover, the behavior of the proposed VM APF was also experimentally measured using commercially available integrated circuit OPA860 by Texas Instruments.