Water inrush disasters from the coal seam floor occur frequently due to the high water pressure of the Ordovician limestone aquifer, multiple aquifers and strong mining disturbance. We presented a model of water-resisting key strata (WRKS) to investigate the mechanism of floor water inrush from multiple aquifers in deep coal mines. Roof hydraulic fracturing (RHF) for controlling floor water inrush and multi-parameter monitoring were proposed and validated in the Xingdong coal mine in Xingtai, Hebei Province. The results indicated that the periodic weighting step of the test working face after RHF was 9.53 m, which was 61.42% less than that of the working face without RHF (24.7 m). The floor failure depth was 30 m, which was 34.4% less than that of the zones without RHF (45.7 m). Hydraulic fracturing weakened the strength of the overlying strata to control the weighting step and reduce the mining disturbance stress, and the stability of the floor WRKS was enhanced, thereby preventing water inrush from the coal seam floor. The research results provide a solution for preventing floor damage and floor water inrush under strong mining disturbance and in complex hydrogeological environments in deep mining.
The extraction of low-permeability coalbed methane (CBM) has the dual significance of energy utilization and safe mining. Understanding hydraulic fracturing mechanism is vital to successful development of CBM. Therefore, it is important to improve the law of hydraulic fracture propagation in coal and rigorously study the influencing factors. In this paper, laboratory experiments and numerical simulation methods were used to investigate the hydraulic fracture propagation law of coal in coalbed methane reservoir with natural fractures. The results show that the maximum and minimum horizontal in situ stress and the difference in stress significantly affect the direction of crack propagation. The elastic modulus of coal, the mechanical properties of natural fractures, and the injection rate can affect the fracture length, fracture width, and the amount of fracturing fluid injected. To ensure the effectiveness of hydraulic fracturing, a reservoir environment with a certain horizontal stress difference under specific reservoir conditions can ensure the increase of fractured reservoir and the controllability of fracture expansion direction. In order to increase the volume of fractured reservoir and fracture length, the pumping speed of fracturing fluid should not be too high. The existence of stress shadow effect causes the hydraulic fracture to propagate along the main fracture track, where the branch fracture cannot extend too far. Complex fractures are the main hydraulic fracture typology in coalbed methane reservoir with natural fractures. The results can provide a benchmark for optimal design of hydraulic fracturing in coalbed methane reservoirs.
The frequency of dynamic disasters is escalating in deep coal mining, with an increasing number of disasters induced by the combined static and dynamic loading. To investigate the mechanical behavior of deep sandstone under mining, cyclic disturbance, uniaxial cyclic loading, and unloading tests with equal amplitude were conducted at four different disturbance rates on the basis of static loading. The influence of loading and unloading disturbance rates on mechanical properties, fracture characteristics, acoustic emission (AE) temporal‐spatial evolution, and fractal characteristics of AE spatial distribution were analyzed. The results show that the peak strength of rock samples initially decreases and then increases as the disturbance rate increases. During the cyclic loading and unloading disturbance stage, AE exhibits a significant Kaiser effect under different disturbance rates. The higher the disturbance rate, the greater the number of cycles with high amplitude AE, but fewer high amplitude AE occur during the loading to peak failure stage. The increment of the damage variable is positively correlated with the loading and unloading disturbance rate overall. The AE spatial fractal dimension in rock samples decreases under different loading and unloading disturbance rates, stabilizing at a range of 2.1–2.3. As the loading and unloading disturbance rate increases, the decreasing magnitude in fractal dimension during the cyclic loading and unloading stage first increases and then decreases, with a relatively smaller decrease during the loading to peak failure stage.