Zinc (Zn)–manganese dioxide (MnO2) rechargeable batteries have attracted research interest because of high specific theoretical capacity as well as being environmentally friendly, intrinsically safe and low-cost. Liquid electrolytes, such as potassium hydroxide, are historically used in these batteries; however, many failure mechanisms of the Zn–MnO2 battery chemistry result from the use of liquid electrolytes, including the formation of electrochemically inert phases such as hetaerolite (ZnMn2O4) and the promotion of shape change of the Zn electrode. This manuscript reports on the fundamental and commercial results of gel electrolytes for use in rechargeable Zn–MnO2 batteries as an alternative to liquid electrolytes. The manuscript also reports on novel properties of the gelled electrolyte such as limiting the overdischarge of Zn anodes, which is a problem in liquid electrolyte, and finally its use in solar microgrid applications, which is a first in academic literature. Potentiostatic and galvanostatic tests with the optimized gel electrolyte showed higher capacity retention compared to the tests with the liquid electrolyte, suggesting that gel electrolyte helps reduce Mn3+ dissolution and zincate ion migration from the Zn anode, improving reversibility. Cycling tests for commercially sized prismatic cells showed the gel electrolyte had exceptional cycle life, showing 100% capacity retention for >700 cycles at 9.5 Ah and for >300 cycles at 19 Ah, while the 19 Ah prismatic cell with a liquid electrolyte showed discharge capacity degradation at 100th cycle. We also performed overdischarge protection tests, in which a commercialized prismatic cell with the gel electrolyte was discharged to 0 V and achieved stable discharge capacities, while the liquid electrolyte cell showed discharge capacity fade in the first few cycles. Finally, the gel electrolyte batteries were tested under IEC solar off-grid protocol. It was noted that the gelled Zn–MnO2 batteries outperformed the Pb–acid batteries. Additionally, a designed system nameplated at 2 kWh with a 12 V system with 72 prismatic cells was tested with the same protocol, and it has entered its third year of cycling. This suggests that Zn–MnO2 rechargeable batteries with the gel electrolyte will be an ideal candidate for solar microgrid systems and grid storage in general.
A 2.5 to 3.4 V Zn|MnO 2 membrane-less solid-state battery accessing the 617 mA h g −1 theoretical capacity of MnO 2 and its application in e-mobility is reported. This concept is made possible by a buffering layer that regulates the battery’s pH.
13 July 2023 in Journal of the American Chemical Society
Rechargeable batteries that function at temperatures as high as 100 °C are desired for drilling instruments, autoclavable medical electronics, and space exploration. However, at 100 °C and beyond, lithium-ion batteries (LIBs) exhibit rapid capacity fade that prevent their use in many applications. Here, an in-depth study of the failure mechanisms was undertaken for LIBs operating at 100 °C containing graphite anodes, LiNi0.33Mn0.33Co0.33O2 (NMC111) cathodes, and organic electrolytes containing lithium hexafluorophosphate (LiPF6) and lithium tetrafluoroborate (LiBF4) salts. Electrochemical methods including differential analyses (dV/dQ) of galvanostatic cycling, electrochemical impedance spectroscopy (EIS), and linear polarization (LP) revealed that capacity loss was caused by a loss of lithium inventory in the cell due to film-forming reactions that siphon capacity. We hypothesized that capacity fade results from continual degradation and reformation of the anode solid electrolyte interphase (SEI), causing low coulombic efficiencies and poor cycle life. Crucially, electrode replacement of either the graphite or NMC111 with lithiated electrodes enabled full capacity recovery after high-temperature cycling, revealing that the electrode materials themselves were not inherently unsuitable for use at 100 °C. Overall, this study identifies the failure mechanisms of LIBs cycling at 100 °C, which are expected to guide the development of electrolyte formulations that improve electrode interphase stability and hence the performance of LIBs operating as high as 100 °C.