This article presents a low detent force double-sided permanent-magnet synchronous linear motor (DS-PMSLM), which contains two flat-type stators and a mover. The mover is constituted of a fiberglass support plate and Halbach array permanent magnets attached on both surfaces of this plate, which provides a large thrust force and low mover mass for high dynamic response. For the sake of reducing the thrust ripple, a modulation method of the cogging and end forces is proposed based on the destructive interference. The even-order harmonics in cogging and end forces are reduced by adjusting the width of the side slots and the lengths of end teeth, respectively. In order to reduce the odd-order harmonics of the detent force, the cogging force and end force are modulated to reverse phases and identical amplitudes by changing the equivalent lengths of four end teeth. An integrated subdomain analytical model considering the cogging and end effects is built to optimize five structural parameters of the stators for low detent force. Finally, the prototype and testing platforms are set up and the experimental results validate that the proposed DS-PMSLM can achieve a low thrust ripple of less than 1.5 $ \%$ .

The intake port structure optimization is very important for the uniflow scavenging opposed-piston two-stroke engine, as the intake port structure affects the scavenging efficiency and turbulence kinetic energy and thus further impacts the engine indicated efficiency. This paper aims at improving the indicated efficiency, presenting a comprehensive study on the intake port optimization concerning both scavenging efficiency and turbulence kinetic energy. First, a three-dimensional model based on computational fluids dynamics is established and validated. Subsequently, different numbers of intake ports are compared and analyzed from the perspectives of the scavenging efficiency and turbulence kinetic energy. Furthermore, the double-ports intake structure is selected with the consideration of the compact structure and high scavenging efficiency. Then, the radial angle and width of the double-ports structure are optimized based on the response surface method. The results show that the optimized structure increases the turbulence kinetic energy in relative high scavenging efficiency. The indicated efficiency exhibits a significant increase within the speed range of 1000–4000 rpm and reaches the maximum value of 39.5% around 2000 rpm.