In this paper, a pyrolysis model for a PVC cable is constructed using results from thermogravimetric analysis, microscale combustion calorimeter and cone calorimeter experiments. The pyrolysis model is used to simulate fire propagation in horizontal cable trays. The simulated arrangement corresponds to a cable tray fire experiment from OECD PRISME 2 project. As laying the cables loosely along the horizontal trays is a random process, a novel stochastic method is developed for making the simplified cable tray geometries for the computational fluid dynamics model. In addition, as the simplified cable tray geometry has significantly smaller surface area than a real tray full of cables, the surface area was parametrically adjusted. In contrast to most of the earlier published numerical approaches for simulating cable tray fires, the presented approach does not use empirical correlations for predicting fire propagation and does not require any results from full-scale experiments for calibrating the model. The simulation results are compared to experimental results in terms of heat release rate, mass loss, tray ignition times and lateral flame spread rates. The maximum heat release rate was overpredicted by 8% on average.
Aging reactions due to heat and radiation cause chain scissions and cross-linking in cross-linked polyethylene (XLPE). We have developed theoretical and numerical graph models to study the evolution of the gel fraction and network properties during aging as well as the mass loss during thermogravimetric analysis (TGA). Our analytical and kinetic Monte Carlo (KMC) based models that combine degradation reactions and a simple vaporization model can quantitatively predict TGA curves for aged XLPE. Fitting the model to experimental TGA data yields the number of scission reactions, showing that thermogravimetry combined with our models can present a nondestructive aging characterization tool for lifetime prediction.
Summary: A fire test series to study pool fires of ethanol‐water mixtures in the small, intermediate and large scale has been performed. Additionally, demonstration tests of piles of PET plastic 0.5‐L liquor bottles (39 vol%) in retail store arrays were carried out to illustrate their burning behaviour. On the basis of the test results, the burning of pool fires of different alcoholic beverages and the fire load due to alcohol can be evaluated for the purpose of performance‐based fire safety design. The fire tests of retail store arrays showed that these fires grow slowly, and their heat release rate maxima are relatively low taking into account the mass of the fire load. The estimated heat release rate maxima of four‐layer retail store arrays were ca. 1.5 MW and their growth times were over 600 seconds. Design fires generally used for the fire safety design of shopping centres are typically much more severe than the fire test results of retail store arrays of alcoholic beverages in this study.