Razvan Corneliu Pop

Mr. Razvan Corneliu Pop


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 November 2020 in European Journal of Dental Education
Verified
Journal Article
Closed access
PDF file
MBMarius Bud
Marius Bud
RPRazvan Pricope
Razvan Pricope
RPRazvan Corneliu Pop
Razvan Corneliu Pop
RORazvan Onaca
Razvan Onaca
PSPieter‐Jan Swerts
Pieter‐Jan Swerts
ADAda Delean
Ada Delean

13 October 2022 in Clinical and Experimental Dental Research
Verified
Journal Article
Open access
MBMarius Bud
Marius Bud
RPRazvan Corneliu Pop
Razvan Corneliu Pop
RPRazvan Pricope
Razvan Pricope
AMAnca Mesaros
Anca Mesaros
AVAndrada Voina
Andrada Voina
SCSanda Cîmpean
Sanda Cîmpean
Objectives: Microleakage in direct dental restorations is a primary causal factor in the restoration's failure. The aim of this study was to evaluate whether the technique for occlusal layering of the composite resin (the use of brush adaptation, the use of magnification, cusp build‐up, stamp technique) has any effect on microleakage of direct restorations in occlusal cavities.Materials and Methods: One hundred extracted human molars were restored using five restoration techniques (Packable Bulk technique, Occlusal Stamp technique, Successive Cusp Build‐up technique, Successive Cusp Build‐up technique + Brush adaptation, Successive Cusp Build‐up technique + brush adaptation + Dental Operative Microscope magnification). The teeth were subjected to thermal aging for 800 cycles at 5°C and 55°C, infiltrated with basic fuchsin dye for 24 h, and then sectioned buccolingually in the middle of the crown. Infiltration was measured in four areas of the tooth section by five different observers and then given a score from 1 to 3, proportional to infiltration depth.Results: The lowest mean scores for infiltration (meaning less infiltration observed) were present in Group A (1.41 ± 0.878) and Group C (1.46 ± 0.679), while Group D showed the highest infiltration scores (1.75 ± 0.853). When comparing the groups for differences, no statistically significant difference in infiltration was found between any technique p < .586.Conclusion: The techniques examined for placing the occlusal layer of composite in direct restorations do not differ significantly in terms of marginal infiltration, although a slight improvement was found when using the bulk technique and the successive cusp build‐up.

Verified
Journal Article
Open access
PDF file
MMMihai Merfea
Mihai Merfea
Ioana-Sofia Pop-CiutrilaIoana-Sofia Pop-Ciutrila
Ioana-Sofia Pop-Ciutrila
MBMindra Eugenia Badea
Mindra Eugenia Badea
Ada Gabriela DeleanAda Gabriela Delean
Ada Gabriela Delean
OCOana Cimponeriu
Oana Cimponeriu
SCSanda-Ileana Cimpean
Sanda-Ileana Cimpean
Background and objectives: Post-operative pain (POP) is a common complication after root canal treatment and is influenced by various clinical and patient-related factors. The present study evaluated the incidence and intensity of POP following root canal treatment using a bioceramic sealer performed by operators with different levels of experience. Methods: A total of 115 patients were included in this prospective observational study. Patients were treated by operators with different levels of experience: postgraduate students (PGSs) and endodontic specialists (ESs). Standardized protocols were used in two distinct appointments: an instrumentation visit and an obturation visit. Obturation was performed using the continuous wave condensation technique and Total Fill Hi-Flow BC Sealer (TFHF). POP, mastication discomfort, and sleep disturbance were assessed at 24, 48, and 72 h after the instrumentation and obturation phases using a numeric rating scale (NRS). Results: The results indicate significantly higher POP after the instrumentation phase, compared to the obturation phase (p < 0.001). The pain intensity progressively decreased over time for both phases. No significant differences were observed between the PGS and ES groups regarding POP, mastication discomfort, or sleep disturbance at any time. Sealer extrusion did not significantly impact POP (p > 0.05). Conclusions: This study found that operator experience does not significantly influence POP when a standardized protocol is followed. The use of TFHF with the continuous wave condensation technique was associated with minimal POP.

26 May 2025 in Preprints.org
Verified
Preprint
Open access
PDF file
MMMihai Merfea
Mihai Merfea
Ioana-Sofia Pop-CiutrilaIoana-Sofia Pop-Ciutrila
Ioana-Sofia Pop-Ciutrila
MBMindra Eugenia Badea
Mindra Eugenia Badea
Ada Gabriela DeleanAda Gabriela Delean
Ada Gabriela Delean
OCOana Cimponeriu
Oana Cimponeriu
SCSanda-Ileana Cimpean
Sanda-Ileana Cimpean
Background and objectives: Post-operative pain (POP) is a common complication after root canal treatment and is influenced by various clinical and patient-related factors. The present study evaluated the incidence and intensity of POP following root canal treatment using a bioceramic sealer, performed by operators with different levels of experience. Material and methods: A total of 115 patients were included in this prospective observational study. Patients were treated by operators with different levels of experience: postgraduate students (PGSs) and endodontic specialists (ESs). Standardized protocols were used in two distinct appointments: an instrumentation visit and an obturation visit. Obturation was performed using the continuous wave condensation technique and Total Fill Hi-Flow BC Sealer (TFHF). POP, mastication discomfort, and sleep disturbance were assessed at 24, 48, and 72 hours after the instrumentation and obturation phases using a numeric rating scale (NRS). Results: The results indicate significantly higher POP after the instrumentation phase, compared to the obturation phase (p < 0.001). The pain intensity progressively decreased over time for both phases. No significant differences were observed between the PGS and ES groups regarding POP, mastication discomfort, or sleep disturbance at any time. Sealer extrusion did not significantly impact POP (p > 0.05). Conclusions: This study found that operator experience does not significantly influence POP when a standardized protocol is followed. The use of TFHF with the continuous wave condensation technique was associated with minimal POP.