This paper presents novel results from size-resolved particulate matter (PM) mass, composition, and morphology measurements conducted during the 2018 southwest monsoon (SWM) season in Metro Manila, Philippines. Micro-orifice uniform deposit impactors (MOUDIs) were used to collect PM sample sets composed of size-resolved measurements at the following aerodynamic cut-point diameters (D_p): 18, 10, 5.6, 3.2, 1.8, 1.0, 0.56, 0.32, 0.18, 0.10, and 0.056 µm. Each sample set was analyzed for composition of the water-soluble fraction. Analysis for mass was carried out on two sample sets, whereas black carbon (BC) and morphology analysis were analyzed on a single sample set. The bulk of the PM mass was between 0.18 and 1.0 µm with a dominant mode between 0.32 and 0.56 µm. Similarly, most of the black carbon (BC) mass was found between 0.10 and 1.0 µm, peaking between 0.18 and 0.32 µm. These peaks are located in the Greenfield gap, or the size range between 0.10 and 1.0 µm, where wet scavenging by rain is relatively inefficient. In the range between 0.10 and 0.18 µm, BC constituted 78.1 % of the measured mass. Comparable contributions of BC (26.9 %) and the water-soluble fraction (33.4 %) to total PM were observed and most of the unresolved mass, which amounted to 39.6 % in total, was for diameters exceeding 0.32 µm. The water-soluble ions and elements exhibited an average combined concentration of 8.53 µg m⁻³, with ${\mathrm{SO}}_{\mathrm{4}}^{\mathrm{2}-}$ , ${\mathrm{NH}}_{\mathrm{4}}^{+}$ , ${\mathrm{NO}}_{\mathrm{3}}^{-}$ , Na⁺, and Cl⁻ as the major contributors. Positive matrix factorization (PMF) was applied to identify the possible aerosol sources and estimate their contribution to the water-soluble fraction of collected PM. The factor with the highest contribution was attributed to “aged aerosol” (48.0 %), while “sea salt” (22.5 %) and “combustion” emissions (18.7 %) had comparable contributions. “Vehicular/resuspended dust” (5.6 %) and “waste processing” emissions (5.1 %) were also identified. Microscopy analysis highlighted the ubiquity of nonspherical particles regardless of size, which is significant when considering calculations of parameters such as single scattering albedo, the asymmetry parameter, and the extinction efficiency. The significant influence from aged aerosol to Metro Manila during the SWM season indicates that local sources in this megacity do not fully govern this coastal area's aerosol properties. The fact that the majority of the regional aerosol mass burden is accounted for by BC and other insoluble components has important downstream effects on the aerosol hygroscopic properties, which depend on composition. The results are relevant for understanding the impacts of monsoonal features on size-resolved aerosol properties, notably aqueous processing and wet scavenging. Finally, the results of this work provide contextual data for future sampling campaigns in Southeast Asia such as the airborne component of the Cloud, Aerosol, and Monsoon Processes Philippines Experiment (CAMP²Ex) planned for the SWM season in 2019.

Leveraging aerosol data from multiple airborne and surface‐based field campaigns encompassing diverse environmental conditions, we calculate statistics of the oxalate‐sulfate mass ratio (median: 0.0217; 95% confidence interval: 0.0154–0.0296; R = 0.76; N = 2,948). Ground‐based measurements of the oxalate‐sulfate ratio fall within our 95% confidence interval, suggesting the range is robust within the mixed layer for the submicrometer particle size range. We demonstrate that dust and biomass burning emissions can separately bias this ratio toward higher values by at least one order of magnitude. In the absence of these confounding factors, the 95% confidence interval of the ratio may be used to estimate the relative extent of aqueous processing by comparing inferred oxalate concentrations between air masses, with the assumption that sulfate primarily originates from aqueous processing.

The low-cost and easy-to-use nature of rapidly developed PM_2.5 sensors provide an opportunity to bring breakthroughs in PM_2.5 research to resource-limited countries in Southeast Asia (SEA). This review provides an evaluation of the currently available literature and identifies research priorities in applying low-cost sensors (LCS) in PM_2.5 environmental and health research in SEA. The research priority is an outcome of a series of participatory workshops under the umbrella of the International Global Atmospheric Chemistry Project–Monsoon Asia and Oceania Networking Group (IGAC–MANGO). A literature review and research prioritization are conducted with a transdisciplinary perspective of providing useful scientific evidence in assisting authorities in formulating targeted strategies to reduce severe PM_2.5 pollution and health risks in this region. The PM_2.5 research gaps that could be filled by LCS application are identified in five categories: source evaluation, especially for the distinctive sources in the SEA countries; hot spot investigation; peak exposure assessment; exposure–health evaluation on acute health impacts; and short-term standards. The affordability of LCS, methodology transferability, international collaboration, and stakeholder engagement are keys to success in such transdisciplinary PM_2.5 research. Unique contributions to the international science community and challenges with LCS application in PM_2.5 research in SEA are also discussed.

We present the first study of the weekly cycles (WCs) of chemically speciated and size‐resolved particulate matter (PM) in Metro Manila, Philippines, a coastal megacity located within a highly complex meteorological environment that is subject to both anthropogenic and natural sources. To measure PM, Micro‐Orifice Uniform Deposit Impactors (MOUDIs) were deployed in Metro Manila from August 2018 to October 2019 and samples were analyzed for ionic and elemental species, including black carbon (BC). The WC in Metro Manila varied remarkably across seasons, linked to shifts in meteorology, transport, and aerosol source. Identified aerosol sources were traffic, local and regional burning, dust, sea salt, and secondary aerosol formation. Direct emissions induced a late workweek peak, while secondary aerosol formation led to a weekend peak in response to precursor buildup mainly from traffic. Seasonal analysis revealed that local burning from solid waste management and agricultural fires induced a strong WC peak while regional burning emissions from the Maritime Continent (MC) and possibly the Asian continent elevated seasonal baseline concentrations of the WC. BC showed a seasonally persistent WC, consistent in magnitude, weekly peak timing, and particle size. The dominant submicrometer WC and the contribution of BC across seasons have important ramifications on public health and policymaking, which are also discussed. As many of the observed WC patterns are undetectable when using only bulk PM, this study demonstrates that a seasonal, size‐resolved, and chemically speciated characterization is required to more fully understand the driving mechanisms governing WCs.

Size-resolved aerosol samples were collected in Metro Manila between July 2018 and October 2019. Two Micro-Orifice Uniform Deposit Impactors (MOUDI) were deployed at Manila Observatory in Quezon City, Metro Manila with samples collected on a weekly basis for water-soluble speciation and mass quantification. Additional sets were collected for gravimetric and black carbon analysis, including during special events such as holidays. The unique aspect of the presented data is a year-long record with weekly frequency of size-resolved aerosol composition in a highly populated megacity where there is a lack of measurements. The data are suitable for research to understand the sources, evolution, and fate of atmospheric aerosols, as well as studies focusing on phenomena such as aerosol-cloud-precipitation-meteorology interactions, regional climate, boundary layer processes, and health effects. The dataset can be used to initialize, validate, and/or improve models and remote sensing algorithms.