In this study, phosphogypsum-based composite cementitious materials (PGCMs) were prepared by adding fixed proportions of additives to calcined phosphogypsum (PG). Samples with dimensions of 40 × 40 × 80 mm and 150 × 150 × 300 mm were used to study the effect of the PG calcination time on the PGCM compressive strength, stress–strain relationship, and failure mode and its mechanism. The test results indicated that the PGCM compressive strength gradually increased as the calcination time increased. When the PG calcination time was 180 min, the compressive strengths of the smaller and larger samples increased by 3 and 3.6 times, respectively, compared with the strengths at a calcination time of 20 min. The main reason for the strength increase was the formation of ettringite and hydrated calcium sulfate dihydrate in the PGCM gel system. Additionally, the PGCM compressive strength was significantly related to the sample size, and its reduction coefficient was between 0.60 and 0.69 at different PG calcination times. As the PG calcination time increased, the peak stress of the PGCM stress–strain curve and the corresponding axial strain increased gradually; moreover, brittle failure became more evident.
A lightweight foam phosphogypsum material (LFPM) was prepared by multi-factor orthogonal and optimization experiments. The effects of foam, quicklime, silica fume and cement on the mechanical and physical properties of this LFPM were studied. The orthogonal experimental results showed that the silica fume content exhibited the most significant effect on the strength of this material, and the cement content exhibited the most obvious influence on the softening coefficient. The comprehensive index analysis indicated that the LFPM with 8% foam, 3.5% quicklime, 3% silica fume and 15% cement was selected as the optimal proportion. The 28 d compressive strength and flexural strength were 3.15 and 0.97 MPa, respectively. The dry density was 809.1 kg/m3, and the 28 d softening coefficient was 0.628. The optimization experimental results showed that the strength and dry density of the sample increased first and then decreased with an increase in the foam stabilizer content. The strength and dry density increased, and water absorption decreased with increasing waterproof agent content.
The application of phosphogypsum in building materials can consume waste phosphogypsum and reduce ecological pressure. In this study, building phosphogypsum was used as the base material, and fly ash, lime, cement, and other materials were added to explore the performance of phosphogypsum-based cementitious composite building materials via orthogonal experimental method. Variance analysis and multiple regression analysis were used to summarize the performance variation of these phosphogypsum-based composite cementitious materials. This work demonstrates that the building phosphogypsum content and the water-cement mass ratio are significant factors affecting the thermal conductivity and mechanical properties of these materials scanning electron microscopy (SEM) analysis showed that the mechanical properties and thermal insulation properties of the prepared phosphogypsum-based composite cementitious materials were good in the C-S-H gel system and ettringite formation uniform specimens. Regression analysis showed a significant relationship between the building phosphogypsum content, fly ash content in the supplementary cementitious material, lime content, water-cement mass ratio, compressive strength, and thermal conductivity. The compressive strength and the thermal conductivity were analyzed by the index membership degree. The comprehensive performance of the phosphogypsum-based composite cementitious materials was evaluated, and basic theoretical research into the use of the phosphogypsum-based composite cementitious materials in a building non-load-bearing wall was carried out.