Engineering rock mass is normally subject to cyclic–dynamic disturbances from excavation, blasting, drilling, and earthquakes. Natural fractures in rock masses can be reactivated and propagated under dynamic and static loadings, which affects the stability of rock mass engineering. However, fractured rock mass failure induced by cyclic-impact disturbances is far from clear, especially considering varying angles between the rock mass and the direction of impact loadings. This work investigated rock deformation and failure characteristics through cyclic impact tests on granite samples with cracks of different angles. A Hopkinson bar was employed for uniaxial cyclic impact tests on granite samples with the crack inclination angles of 0–90°. The magnetic resonance imaging technique was used to determine rocks’ porosity after cyclic impacts. The stress–strain curves, porosity, strength, deformation modulus, failure modes, and energy density of samples were obtained and discussed. Results showed that the crack inclination angles significantly affected the damage evolution and crack morphology of rocks. Under the constant cyclic impact, the dynamic deformation modulus and dynamic strength of rock samples first increased and then decreased with the increase in crack inclination angle. The failures of granite samples for inclination angles of 0 and 90° were dominated by tensile cracking, while those for the inclination angles of 30–60° were dominated by shear cracking. The energy density per unit time gradually decreased with the increase in impact cycles. The results can provide references for the stability analysis and cyclic-impact-induced failure prediction of fractured rock masses.

Rock excavation has experienced complex stress paths. The development of the original crack under the path of principal stress magnitude and principal stress direction is a key scientific problem that needs to be solved in rock underground engineering. The principal stress magnitude dominates the initiation and propagation of the crack and increases rock damage under the action of principal stress rotation. In this study, the theoretical calculation and numerical analysis method have been combined with the crack propagation conditions to study the stress‐driven mechanism of brittle rock crack propagation under principal stress rotation. The results show that the “relative initial angle” of crack angle is being updated in time during the principal stress rotation process; once the stress is rotated, it will become the next initial crack angle; the crack propagation direction is deviated under the applied shear load, and it is always in the direction of minimum shear load, leading to a certain degree of inhibition of crack propagation depth in the initial direction. According to the results of numerical simulation, the effect of principal stress rotation caused by mining excavation is obvious and has a certain range of influence depth, the stress of surrounding rock of roadway is the highest within the depth range of 1∼2 m, and the maximum principal stress is as high as 26.89 MPa. The rotation of principal stress direction on the roadway surrounding rock surface is the strongest, which makes the surrounding rock more fragmented, and the middle principal stress and the maximum principal stress rotate about 90° counterclockwise along the Ox axis. Studying the action mechanism of principal stress rotation on fractured rock masses can provide scientific basis for geotechnical engineering design and rock mass surrounding support.

Crustal stress is a critical parameter utilized to analyze the stability of the tunnel in underground hard‐rock mining sites. In order to analyze the distribution law of crustal stress and its influence on the stability of the deep tunnel in the Huanaote mining area, the in‐situ stress field model of this area was constructed firstly by using the borehole stress relief method. Moreover, the numerical model is established based on three real engineering conditions: the excavation direction is parallel, vertical, and intersection to the measured maximum horizontal principal stress direction, respectively. Results show that, compared with the other two layout schemes, the stress of two side walls reaches peak at 27 MPa, when the excavation direction is intersected to the measured maximum horizontal principal stress direction, which indicates that the support and maintenance of two side walls should be strengthened to ensure the stability of the tunnel and the safety of personnel and equipment in real projects.