The Wavelength-shifting Optical Module (WOM) is a novel photosensor concept for the instrumentation of large detector volumes with single-photon sensitivity. The key objective is to improve the signal-to-noise ratio, which is achieved by decoupling the photosensitive area of a sensor from the cathode area of its photomultiplier tube (PMT). The WOM consists of a transparent tube with two PMTs attached to its ends. The tube is coated with wavelength-shifting paint that absorbs ultraviolet photons with nearly 100% efficiency. Depending on the environment, e.g., air (ice), up to 73% (41%) of the subsequently emitted optical photons can be captured by total internal reflection and propagate towards the PMTs, where they are recorded. The optical properties of the paint, the geometry of the tube, and the coupling of the tube to the PMTs have been optimized for maximal sensitivity based on theoretical derivations and experimental evaluations. Prototypes were built to demonstrate the technique and to develop a reproducible construction process. Important measurable characteristics of the WOM are the wavelength-dependent effective area, the transit time spread of detected photons, and the signal-to-noise ratio. The WOM outperforms bare PMTs, especially with respect to the low signal-to-noise ratio with an increase of a factor up to 8.9 in air (5.2 in ice). Since the gain in sensitivity is mostly in the UV regime, the WOM is an ideal sensor for Cherenkov and scintillation detectors.
The Ultraviolet Transient Astronomical Satellite (ULTRASAT) is a scientific space mission carrying an astronomical telescope. The mission is led by the Weizmann Institute of Science (WIS) in Israel and the Israel Space Agency (ISA), while the camera in the focal plane is designed and built by Deutsches Elektronen Synchrotron (DESY) in Germany. Two key science goals of the mission are the detection of counterparts to gravitational wave sources and supernovae.1 The launch to geostationary orbit is planned for 2024. The telescope with a field-of-view of ≈ 200 deg2, is optimized to work in the near-ultraviolet (NUV) band between 220 and 280 nm. The focal plane array is composed of four 22:4-megapixel, backside-illuminated (BSI) CMOS sensors with a total active area of 90 x 90mm2.2 Prior to sensor production, smaller test sensors have been tested to support critical design decisions for the final flight sensor. These test sensors share the design of epitaxial layer and antireflective coatings with the flight sensors. Here, we present a characterization of these test sensors. Dark current and read noise are characterized as a function of the device temperature. A temperature-independent noise level is attributed to on-die infrared emission and the read-out electronics' self-heating. We utilize a high-precision photometric calibration setup3 to obtain the test sensors' quantum efficiency relative to PTB/NIST-calibrated transfer standards (220-1100 nm), the quantum yield for λ >300 nm, the non-linearity of the system, and the conversion gain. The uncertainties are discussed in the context of the newest results on the setup's performance parameters. From the three ARC options Tstd, T1 and T2, the last assists the out-of-band rejection and peaks in the mid of the ULTRASAT operational waveband. We recommend ARC option T2 for the final ULTRASAT UV sensor.
The Wavelength-shifting Optical Module (WOM) is a novel photosensor concept for the instrumentation of large detector volumes with single-photon sensitivity. The key objective is to improve the signal-to-noise ratio which is achieved by decoupling the photosensitive area of a sensor from the cathode area of its photomultiplier tube (PMT). The WOM consists of a transparent tube with two PMTs attached to its ends. The tube is coated with wavelength-shifting paint absorbing ultra-violet photons with nearly $100\,\%$ efficiency. Depending on the environment, e.g. air (ice), up to $73\,\%$ $(41\,\%)$ of the subsequently emitted optical photons can be captured by total internal reflection and propagate towards the PMTs where they are recorded. The optical properties of the paint, the geometry of the tube and the coupling of the tube to the PMTs have been optimized for maximal sensitivity based on theoretical derivations and experimental evaluations. Prototypes were built to demonstrate the technique and to develop a reproducible construction process. Important measurable characteristics of the WOM are the wavelength dependent effective area, the transit time spread of detected photons and the signal-to-noise ratio. The WOM outperforms bare PMTs especially with respect to the low signal-to-noise ratio with an increase of a factor up to 8.9 in air (5.2 in ice). Since the gain in sensitivity is mostly in the UV-regime, the WOM is an ideal sensor for Cherenkov and scintillation detectors.