SRINIVASA RAO GAMPA

Dr. SRINIVASA RAO GAMPA

SR Gudlavalleru Engineering College, Vijayawada, India
orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2020 in Journal of Energy Storage
Verified
Journal Article
Closed access
SGSRINIVASA RAO GAMPA
SRINIVASA RAO GAMPA
KJKiran Jasthi
Kiran Jasthi
Preetham GoliPreetham Goli
Preetham Goli
DDD. Das
D. Das
RBR.C. Bansal
R.C. Bansal

1 March 2015 in International Journal of Electrical Power & Energy Systems
Verified
Journal Article
Closed access
SGSRINIVASA RAO GAMPA
SRINIVASA RAO GAMPA
DDD. Das
D. Das

1 May 2016 in International Journal of Electrical Power & Energy Systems
Verified
Journal Article
Closed access
SGSRINIVASA RAO GAMPA
SRINIVASA RAO GAMPA
DDD. Das
D. Das

6 August 2014 in International Journal of Electrical Power & Energy Systems
Verified
Journal Article
Closed access
SGSRINIVASA RAO GAMPA
SRINIVASA RAO GAMPA
DDDebapriya Das
Debapriya Das

Verified
Journal Article
Open access
PDF file
SGSatish Kumar Gudey
Satish Kumar Gudey
MMMalla Mohan
Malla Mohan
KJKiran Jasthi
Kiran Jasthi
SGSRINIVASA RAO GAMPA
SRINIVASA RAO GAMPA
The performance of electric drive propulsion systems is often degraded by the high torque and flux ripples of an electric drive. Traditional control methods, such as proportional plus integral (PI) controllers and classical sliding mode controllers (SMCs), have shown good response and reduced torque ripple, but even lower ripple content at low voltage levels is required for its effective use in electric vehicle (EV) applications. In this paper, a new direct torque control (DTC) technique with space vector pulse width modulation (SVPWM) using fractional-order sliding mode control (FOSMC) for a two-level inverter (2LI) at constant switching frequency is proposed. The effectiveness of this proposed controller is compared with a conventional proportional-integral controller and a conventional sliding mode controller (SMC). Simulink models are developed using MATLAB version R2018a to analyze the robustness of the proposed control strategy. Simulation results demonstrate the advantage of the proposed controller in reducing the torque ripples at steady state with less settling time during sudden load change conditions. The proposed control technique also demonstrates better utilization of the stator flux through flux trajectory waveforms.

27 November 2019 in Journal of Electrical Systems and Information Technology
Verified
Journal Article
Open access
PDF file
SGSRINIVASA RAO GAMPA
SRINIVASA RAO GAMPA
DDDebapriya Das
Debapriya Das
This paper presents a combination of fuzzy and genetic algorithm (GA)-based methodology for simultaneous optimum allocation and sizing of distributed generations (DGs) and shunt capacitors (SCs) together in distribution systems. The objectives of reduction of active power and reactive power supply, reduction of real power loss and improvement of branch current capacity, voltage profile and voltage stability are considered. The combination of shunt capacitors with both unity power factor DGs and lagging power factor DGs also considered for analyzing the performance of the distribution systems. Simulation results are demonstrated to show the advantage of proposed fuzzy genetic algorithm-based technique over conventional multiobjective approach and loss sensitivity-based optimization techniques reported in the literature.